MV-9_Chapter 5. Teaching.pdf - 第273页

错误 ! 使用“开始” 选项卡将 제목 2 应用于要在此处显示的文字。错误 ! 使用“开始”选项卡将 제목 2 应用于要在此处显示的文字。 . 5- 273 45 Set Distance Of fset - In case of Center Point: Set X, Y Of fsets on the basis of the Center Points of m a rkers. - In case of Line Dis…

MV-9 User Manual

5-272

< Use three markers: Center Point>

错误!使用“开始”选项卡将 제목 2 应用于要在此处显示的文字。错误!使用“开始”选项卡将 제목 2 应用

于要在此处显示的文字。 .

5-273

45 Set Distance Offset

- In case of Center Point: Set X, Y Offsets on the basis of the Center Points of markers.

- In case of Line Dist.: Set X and Y Offsets on the basis of the first marker.

- In case BLU is not located at the center of BLU Bar or in case the markers are

misplaced, it is possible to adjust the reference values for Center Point of BLU to be

inspected by using X and Y Offsets.

MV-9 User Manual

5-274

46 Register ID of markers on the 3D BLU inspection window.

47 Select „Edit Part‟ mode.

48 Select the mounting inspection window for 3D BLU.

49 If the 1st ID (the 2nd ID or 3rd ID) is clicked from maker ID‟s and the previous inspection

window is selected, the marker ID is registered.

5.9.9 Teaching Method in case of No Markers (Use RectCenter)

① After drawing the inspection window for position move at the top, the bottom and both

pad ends, as shown in the following figure, tie the parts.