MV-9_Chapter 5. Teaching.pdf - 第248页

MV -9 Use r Manual 5- 248 This is to e q ually a dj ust width interval of the selected inspection windows.  Same height interval This is to e q ually a dj ust h e i ght interval of the selected i nspection w i ndows.

错误!使用“开始”选项卡将 제목 2 应用于要在此处显示的文字。错误!使用“开始”选项卡将 제목 2 应用

于要在此处显示的文字。 .

5-247

[Figure 5-325 Bottom alignment of inspection windows]

 Left

This is to align based on left side of reference inspection window.

 Center

This is to align based on center of reference inspection window.

 Right

This is to align based on right side of reference inspection window.

 Size

This is used to adjust size of many inspection windows based on reference inspection window.

[Figure 5-326 size adjustment of inspection windows]

 Width

This is to set width of the selected inspection windows to the same size of width of reference

inspection window.

 Height

This is to set height of the selected inspection windows to the same size of height of reference

inspection window.

 All (width ∙ height)

This is to set width and height of the selected inspection windows to the same size of width

and height of reference inspection window.

 Same width interval

Before alignment

After alignment

Reference

window

inspection

MV-9 User Manual

5-248

This is to equally adjust width interval of the selected inspection windows.

 Same height interval

This is to equally adjust height interval of the selected inspection windows.

错误!使用“开始”选项卡将 제목 2 应用于要在此处显示的文字。错误!使用“开始”选项卡将 제목 2 应用

于要在此处显示的文字。 .

5-249

5.6 3D Teaching

The objective is to inspect the lift of even parts (Chip).

5.6.1 Selection of Window for Mounting Inspection

With the window button, select and add the window for mounting inspection.( ).

* In general, a new window is not added and “Use 3D Inspect“ option is checked and used on

the window for mounting inspection which has already been taught.

5.6.2 Selection of “Use 3D Inspect “Option

Check “Use 3D Inspect” item in the window parameters for mounting inspection.

5.6.3 Projector Selection

Select the projector to be used in the inspection.

- It is possible to select the east, west, south and north projectors, and they are selected

by default values.

- In general, it is recommended that 4 projectors be used.

In case only one projector is used, the measurement may not be made due to noise.