N7201A616E00_0317.pdf - 第117页

NPM-W 2 EJM7DE-MB-02O-0 0 First layer Second layer Third layer Fourth layer 2-2-2 -16 Head (Dispensing head) Checks origin offset. Checks rotation center offset of a head. Checks offset of a head per angle. Checks height…

100%1 / 714
NPM-W2 EJM7DE-MB-02O-00
First layer Second layer Third layer Fourth layer
2-2-2-15
XY unit
Compo-
nent
names
Menu configuration 8
Operating procedure
2-2-2
Engineer mode 6
Machine
menu
Setup
Configures parameters.
Configures optional functions.
Height
sensor
Whole
Parameter
Confirms data check results.
Checks the origin offset.
Checks the offset of a reference mark of the
XY unit.
Checks the parameter for the plane
correction of the placement range.
Checks the offset of placement position.
Head
Checks the head rotation center offset.
Checks the offset at each head angle.
Checks the offset of the head origin.
Checks the nozzle changer offset.
Checks the parameter for load control.
(displayed when the 3-nozzle head is installed)
Configures the parameters.
Multi-
recognition
camera
Configures optional functions.
NPM-W2 EJM7DE-MB-02O-00
First layer Second layer Third layer Fourth layer
2-2-2-16
Head
(Dispensing
head)
Checks origin offset.
Checks rotation center offset of a
head.
Checks offset of a head per angle.
Checks height offset of dummy
dispensing.
Checks the origin offset.
Conveyor
Checks PCB control position offset.
Checks pickup position offset.
Feeder
Checks the offsets of squeegee-axis
and transcription position.
Tray
Checks the origin offset.
Checks pickup position offset.
Preparation
Checks the offset correction values
for X-, Y-, and -axes of the camera.
Checks white balance correction
values for the camera.
Checks the amount of correction of
lamp value.
Checks the offset of four-point
position of reference post.
Checks the parameter used to set
plane correction up as the inspection
range.
Inspection
head
NPM-W2 EJM7DE-MB-02O-00
First layer Second layer Third layer Fourth layer
2-2-2-17
Engineer mode 7
Compo-
nent
names
Menu configuration 9
Operating procedure
2-2-2
Machine
menu
Parameter
Checks and enters the offset
correction coefficient of the height
sensor.
Height sensor
Calibration
First step
Second
step
Measures XY-origin and the head
camera.
Obtains measurements required to
calculate the XY offset of the
placement range.
Measures the origin offset of Z-axis,
and obtains measurements required
to calculate the height offset of the
placement range.
Configures the origin offset of the
adjustment width.
Corrects the height sensor.
Configures the parameter for load
control.
Sets a PCB stop position and
placement height offset.
(for the 3-nozzle head)
Checks the offset and scale of the
head camera.
Checks the lamp values to be set to
the recognition device.
Head
camera
Multi-
recognition
camera
Checks the offset and magnification
of the component recognition camera.
Checks the lamp values to be set to
the recognition device.
Checks and enters the lamp values to
be set to the recognition device.