N7201A616E00_0317.pdf - 第137页
NPM-W 2 EJM7DE-MB-02 O-00 2-4-1 -2 Preparatio n 2 1 Installing the thin type tape feeder Cut the carrier tape Attach the feeder to the attachment Align the fe eder edge to th e insertion slot of the ded icated attachment…
NPM-W2 EJM7DE-MB-02O-00
Prepara-
tions
before
produc-
tion
Operating procedure
2-4-1
Preparation of the
intelligent feeder 1
2-4-1-1
2
1
Cut the carrier
tape
Attach the feeder to the feeder base
Align the end of the feeder with
a slot and insert it into the
feeder base.
3
Pull up the lever and push
it all the way inside.
Carrier tape
Attach the reels
■Large reel
Place the large reel on the
lower curved surface.
Make sure that the reel can rotate.
●Depending on the setting
condition of the adjacent
reel, install the separator.
●Use a spindle for a heavy
reel that does not rotate
smoothly.
( →P. 2-4-1
-5)
■Small reel
Place the reel.
Raise the lever until it touches the lower
small reel guide.
●Pull the lever toward you and lower it to the
stopper.
2
1
1
2
1
2
1
2
2
1
Installing the double tape feeder
●About replacement of components(→P.3-3-1)
This section describes how to install and remove the double tape feeder and thin type tape feeder.
(→[Intelligent tape feeder] operating manual)
NPM-W2 EJM7DE-MB-02O-00
2-4-1-2
Preparation
2
1
Installing the thin type tape feeder
Cut the carrier
tape
Attach the feeder to the attachment
Align the feeder edge to the
insertion slot of the dedicated
attachment and insert.
Pull down the lever and insert it
all the way inside.
Confirm that the dedicated attachment has been installed.
2
1
●Refilling the substitution part (→P.3-3-1)
Carrier tape
To step on the left page
3
2
Align the attachment edge to
the slot and insert
Pull up the lever and insert
all the way inside
1
1
2
■How to attach the dedicated attachment
■How to attach the thin type tape feeder
NPM-W2 EJM7DE-MB-02O-00
2-4-1-3
Prepara-
tions
before
produc-
tion
Operating procedure
2-4-1
Preparation of the
intelligent feeder 2
Removing the double tape feeder
2
1
1
2
Lift up the rear
side and remove
the feeder with
both hands
Pull up the lever
and pull out the
feeder
How to hold the feeder
Hold the parts with
both hands
Batch exchange using the feeder cart (option)
Pay attention to your surroundings when you move the feeder
cart
(Risk of injury in a collision with the cart )
WARNING
Setting up production feeders on the spare feeder cart in advance allows you to replace the feeders by one
operation during a changeover. (→[Maintenance] P.3-2)