N7201A616E00_0317.pdf - 第167页
NPM-W 2 EJM7DE-MB-02O-0 0 2-5-2 -8 Preparatio n D E Material F The barcode-sca nne d nozzle serial number ‘- - - (Hyphen)’: Yet to be measured Failed to read Serial The barcode-sca nned extra nozzle information ‘- - - (H…
NPM-W2 EJM7DE-MB-02O-00
Individu-
al
prepara-
tion
Replacing the nozzle 4
2-5-2-7
Operating procedure
2-5-2
A B C D E F
1
2
Nozzle 2D code recognition
The nozzle 2D recognition is carried out, and its results are displayed on the screen.
This is used to prevent miss setting of the nozzles. At the start of automatic operation, the nozzle 2D code
recognition is carried out so as to detect a nozzle(s) being miss set.
The [2D code chk] and [Read value] buttons are active only when “the nozzle 2D code recognition” is ON in
the Option setting (→P.7-1-1).
The screens for 12-nozzle heads are used here as an example to illustrate; however, the same procedure is
also applicable to light weight 16-, 8-, and 3-nozzle heads.
1
<2D code recognition result> screen
(All nozzles are returned to the changer,
and the 2D codes of all the nozzles
within the changer are recognized)
2
(2D code recognition results are displayed)
A
The nozzle changer number
Changer
B
The nozzle number in production data
Nozzle Name Prod. data
C
The barcode-scanned nozzle number
‘- - - (Hyphen)’:
Yet to be scanned
Failed to read
Yellow frame:
The nozzle number differs from the
one in production data.
Nozzle Name Bar code
+
NPM-W2 EJM7DE-MB-02O-00
2-5-2-8
Preparation
D
E
Material
F
The barcode-scanned nozzle serial number
‘- - - (Hyphen)’:
Yet to be measured
Failed to read
Serial
The barcode-scanned extra nozzle information
‘- - - (Hyphen)’:
Yet to be measured
Failed to read
Other information
The barcode-scanned nozzle material
‘- - - (Hyphen)’:
Yet to be measured
Failed to read
NPM-W2 EJM7DE-MB-02O-00
OFF
SERVO
2-5-3-1
1
ENABLING
After removing
PCBs
2 3
ENABLING
Detach the feeder
cart
(→[Maintenance]
P.3-2)
5
4
7
Cover the line
camera with the
lint-free cloth
6
Hold the feeder
table cover to
the back
Individu-
al
prepara-
tion
Setting support pins 1
Operating procedure
2-5-3
Confirm a
message
Only when the machine and its back side are intended for dual conveyor specifications and feeder cart
specifications, respectively and the machine is in the dual lane mode, remove or attach the PCB support
blocks, starting with the one that is closest to you. Otherwise, start with the front side.