N7201A616E00_0317.pdf - 第441页
NPM-W 2 EJM7DE-MB-06O-0 0 16 6-2-2 -6 16 17 + Confirm the message 17 ● You may transition to the other screen. ■ T o reconfirm the data 15 15 (The measurement result of the recognition mark is displayed again) ■ When the…
NPM-W2 EJM7DE-MB-06O-00
+
13
13
(The measurement result of the recognition
mark is displayed)
6-2-2-5
Produc-
tion data
teaching
PCB recognition teach
3
Teaching 2
14
14
Confirm the measurement result
Operating procedure
6-2-2
NPM-W2 EJM7DE-MB-06O-00
16
6-2-2-6
16
17
+
Confirm the message
17
●You may transition to the other
screen.
■To reconfirm the data
15
15
(The measurement result of the
recognition mark is displayed again)
■When the PCB is not unloaded
+
Setting
change
NPM-W2 EJM7DE-MB-06O-00
6-2-2-7
Produc-
tion data
teaching
PCB recognition teach
4
Operating procedure
6-2-2
This is used when the shape of a recognition target (mark) is too complex to be sharply defined, or when a
recognition target is too large to fit in the recognition screen.
Note that, when using this function, you should set the shape type of PCB recognition marks for 1 point block
on DGS. You can check on the PCB recognition data screen or the PCB recognition teach screen to see
whether it has been set for 1 point block.
Display the <Main menu> screen in advance, and send PCB data used to change production PCBs from
NPM-DGS.
Put a PCB at the PCB loading
entrance
1
2
Close the safety cover
3
(The PCB is loaded and clamped at the
unloading position. The head camera
moves to the recognition mark position.)
4
4
Make a fine adjustment or
inching of the mark so that it is
centrally-located
5
A
Adjust the lamp value so that the mark
Can be seen clearly.
A
Block match 1
Servo switch ON
+