N7201A616E00_0317.pdf - 第654页

NPM-W 2 EJM7DJ-MB-08O-00 System function details Operating procedure 8-2-3 Pr ecautions on oper a tion 1 The correction angle is calculated from angle joining more than two solder center of gravity. Therefore, as for the…

100%1 / 714
NPM-W2 EJM7DJ-MB-08O-00
8-2-2-4
APC
system
NPM-W2 EJM7DJ-MB-08O-00
System
function
details
Operating procedure
8-2-3
Precautions on
operation 1
The correction angle is calculated from angle joining more than two solder center of gravity. Therefore, as
for the component such as smaller number of electrode of chip components and narrower distance
between electrodes, the measurement result will not be fixed and it is not appropriate for correction. We
recommend not using for these components since they are enough to correct only XY direction.
●Please use the design value for the placement coordinate data or PCB recognition coordinate data.
Regarding A (angle) correction of a placement position
Confirmation method of APC applied PCB
8-2-3-1
■APC system requirements
●Bad beam of the solder inspection head is set to OFF
●Inspection of the adjustment setting is set to ON
●LNB is connected
●Forced ejection of PCB transport is set to OFF
When APC is used, PCBs being not produced should not be inserted from the inspection ejection
conveyor. Doing so may cause a PCB transport error.
If the APC system is not applied, APC system requirements might not be satisfied or configuration settings
might be set incorrectly. Please check that system requirements are satisfied and settings are set correctly.
When APC is not applied
A
APC
A
APC
●It is displayed only when APC is
applied.
NPM-W2 EJM7DJ-MB-08O-00
8-2-3-2
Location Large category Item Setting Remarks
Machine Special option
APC system
ON
License registration is required for all
sending and receiving machines.
DGS
1)
(Production
data)
Data creation job
editor
→
Communication
setting
(communication
switch)
Receiving inspection
information (APC)
ON
First machine: OFF
Middle machine: ON
Last machine: ON
Sending inspection
information (APC)
ON
First machine: ON
Middle machine: ON
Last machine: OFF
2D inspection
editor
→
PCB detailed
data setting
FF placement
control
ON For placement position correction
FF inspection
control
ON
For component inspection position
correction
Inspection NG skip
ON
For placement skip by the inspection
result
2D inspection
editor
→
Component
detailed setting
FF placement
control
ON For placement position correction
FF placement
control direction
(X direction)
ON For X direction position correction
FF placement
control direction (Y
direction)
ON For Y direction position correction
FF placement
control direction
(rotation direction)
ON
With angle correction
(Package component, connector, etc.)
OFF
With or without angle correction
(Chip components)
Specifying
measurement
target component
for FF correction
ON
APC mode: [APC correction per
pattern]
●Set more than one point per pattern.
APC mode: [Two points APC
correction]
●Set more than two points per
pattern.
OFF
APC mode: [ACF correction per
mount]
●The setting is not required.
Soft switch Inspection ON Solder inspection is required
■Required setting items
1)How to setup, (→Chapter 2 ‘EDITING THE PRODUCTION DATA’
in the [NPM-DGS 2D inspection editor] Operating Instruction)
Solder inspection
standard
APC
system