N7201A616E00_0317.pdf - 第119页

NPM-W 2 EJM7DE-MB-02O-0 0 First layer Second layer Third layer Fourth layer 2-2-2 -18 Third step Sets the origin offset of the head θ - axis an d the multi- recognition camera magnification. Measures s can position o ffs…

100%1 / 714
NPM-W2 EJM7DE-MB-02O-00
First layer Second layer Third layer Fourth layer
2-2-2-17
Engineer mode 7
Compo-
nent
names
Menu configuration 9
Operating procedure
2-2-2
Machine
menu
Parameter
Checks and enters the offset
correction coefficient of the height
sensor.
Height sensor
Calibration
First step
Second
step
Measures XY-origin and the head
camera.
Obtains measurements required to
calculate the XY offset of the
placement range.
Measures the origin offset of Z-axis,
and obtains measurements required
to calculate the height offset of the
placement range.
Configures the origin offset of the
adjustment width.
Corrects the height sensor.
Configures the parameter for load
control.
Sets a PCB stop position and
placement height offset.
(for the 3-nozzle head)
Checks the offset and scale of the
head camera.
Checks the lamp values to be set to
the recognition device.
Head
camera
Multi-
recognition
camera
Checks the offset and magnification
of the component recognition camera.
Checks the lamp values to be set to
the recognition device.
Checks and enters the lamp values to
be set to the recognition device.
NPM-W2 EJM7DE-MB-02O-00
First layer Second layer Third layer Fourth layer
2-2-2-18
Third step
Sets the origin offset of the head θ-
axis and the multi- recognition
camera magnification.
Measures scan position offset, multi-
recognition camera magnification and
camera tilt.
Measures the θ-axis origin offset and the
rotation center related to a head and the
offset per angle of the dispensing head .
Measures brightness of the standard
lighting.
(displayed when the dispensing head is installed)
(displayed when the inspection head is installed)
Measures position relations between
the head camera and the inspection
camera.
(displayed when the inspection head is installed)
Measures required for calculating XY
correction of an inspection range.
(displayed when the inspection head is installed)
Measures the pickup height and
position.
Measures the pickup height and
position offsets of the tray.
(tray only)
Unit
replacement
Measures the origin offset of Z-axis.
(displayed when the inspection head is installed)
Forth step
Corrects camera image distortion.
Preparation
History
Displays a history of calibrations.
Measures the transcription position
offset height.
NPM-W2 EJM7DE-MB-02O-00
First layer Second layer Third layer Fourth layer
2-2-2-19
Compo-
nent
names
Menu configuration 10
Operating procedure
2-2-2
Machine menu
Checks the connection status of plug-
and-play on the machine.
Checks the PnP history.
Updates machine system software,
messages, recognition system
software, and kernels.
Checks the system software history.
Displays special options being
enabled.
Checks system software information.
Information
PnP
Machine
Loads the common parameters
selected from LNB or the SD card.
Checks firmware information.
Updates each firmware program set
to the machine.
Firmware
Checks the firmware history.
Checks feeder information.
Updates the firmware of each feeder.
Feeder
Engineer mode 8