N7201A616E00_0317.pdf - 第423页

NPM-W 2 EJM7DE-MB-06O-0 0 6-1-20 -2 Setting change 6-1-20 -2 Setting change Item Description Safe mode action (For 3-nozzle hea d) Perform the following when [ON] is set. ・ Do not allow superpo sition of X-axis, Y-axis a…

100%1 / 714
NPM-W2 EJM7DE-MB-06O-00
6-1-20-1
You can set the operation conditions or switch a pass table between ON and OFF.
A
D
B
Item
Shows the previous or next table.
Set
C
Data
editing
Soft switch setting
Displays soft switch items.
●
●
:Enable.
:Disable.
Operating procedure
6-1-20
A
B
C
D
Set pass
●
●
:Pass.
:Not pass.
About settings other than the items
in the next page, see the operating
instruction of NPM-DGS.
NPM-W2 EJM7DE-MB-06O-00
6-1-20-2
Setting
change
6-1-20-2
Setting
change
Item Description
Safe mode action
(For 3-nozzle head)
Perform the following when [ON] is set.
・Do not allow superposition of X-axis, Y-axis and Y-axis during
pickup or placement
・Do not allow preliminary lowing during pickup or placement.
・Pickup check is performed by the vacuum sensor before X-axis or
Y-axis are moved during pickup or placement, and if pickup error is
detected, the action stops regardless of pickup error count.
High production
mode(F)
Perform the following when [ON] is set.
・Production is performed in high-production mode on the machine
front side
*1) *2) *3)
High production
mode(R)
Perform the following when [ON] is set.
・Production is performed in high-production mode on the machine
rear side.
*1) *2) *3)
*1)
It is enabled when the light weight 16-/12-nozzle head is installed.
*2)
When OFF is set, production is performed in “High-accuracy mode”.
*3)
About “High-production mode” and “High-accuracy mode”. (→P.9-1-1 ‘Basic performance’)
NPM-W2 EJM7DE-MB-06O-00
Data
editing
Library check 1
Describes how to check available nozzles or feeder information.
●Edit on NPM-DGS if necessary.
Nozzle library (placement head)
6-1-21-1
Operating procedure
6-1-21
A
B
H
Max Height
F
G
Pickup height
Size X/Size Y
C
E
Nozzle information
(→P.6-1-21-1, -2)
NozzleName
Nozzle total height.
●Unit: mm.
The height from the nozzle top to the
pickup surface.
●Unit: mm.
The dimension in the X-/Y-direction as
seen from the top of the nozzle.
●Unit: mm.
C A
B
Shows the previous or next table.
(Scrolls the table to the right.)
D
NzlNo.
I
Recog Mode
Nozzle recognition method.
Recognition
mode
Nozzle recognition
method
Reflect Reflection recognition
Transparency Transparency recognition
Both
Available for both
reflection and
transparency recognition