N7201A616E00_0317.pdf - 第710页

NPM-W 2 EJM7DE-MB-09O -00 9-1-1 1 Specifi- cation Operating procedure 9-1-1 1 Suppor ting 03015R component placement (Option) Item Description Head Light weight 16-nozzle head Nozzle No.276S No.276SN Feeder 4 mm double t…

100%1 / 714
NPM-W2 EJM7DE-MB-09O-00
9-1-10-4
■High-speed/High-efficiency mounting line
Independent mode plus Alternative mode
Independent mode Alternative mode
●Line configuration that utilizes the merits
of Independent and Alternate modes.
●Chip parts can be mounted faster, and
atypical or tray components, more
efficiently.
■Imbalanced mounting line
Independent mode plus Alternative mode (front)
Independent mode Alternative mode (front)
●You may configure the mounting line
shown in the left figure if unable to
achieve a production balance between
the front and rear sides.
e.g.)
Board A :
300 placement points (chip parts only)
Board B :
600 placement points (chip parts plus
atypical components)
At
a glance
NPM-W2 EJM7DE-MB-09O-00
9-1-11
Specifi-
cation
Operating procedure
9-1-11
Supporting 03015R
component placement
(Option)
Item Description
Head Light weight 16-nozzle head
Nozzle
No.276S No.276SN
Feeder 4 mm double tape feeder (custom specifications)
*1)
Production mode High production mode “OFF”
*2)
Component 03015R (Panasonic)
*3)
Placement angle
The following four angles only: 0/90/180/270°
*2)
Component recognition Placement angle recognition
*2)
Others
The inspection head of the NPM series and the APC function
are not supported
NPM-W2 supports 03015 chips under the following specifications.
*1) For 4 mm feeder, contact PSFC, or sales subsidiary / sales agency.
*2) How to set (See →P.6-1-20 ‘Soft switch setting’)
*3) Parts except for 03015R (Panasonic) are excluded from warranty.
NPM-W2 EJM7DE-MB-09O-00
Specifi-
cation
Operating procedure
9-1-12
Supporting placement
accuracy ±0.025 mm
(Option)
At
a glance
Item Description
Head Light weight 16-nozzle head
Production mode High production mode “OFF”
*1)
Component 1005JIG
*2)
Placement angle
The following four angles only; 0/90/180/270°
Component recognition Placement angle recognition
*1)
Placement accuracy
±0.025 mm (Cpk ≧ 1)
NPM-W2 supports an accuracy of ±0.025 mm under the following specifications.
*1) How to set (See →P.6-1-20 ‘Soft switch setting’)
*2) Above placement accuracy are guaranteed under the use of 1005JIG chip
9-1-12-1