00198178-04_GS_FeederManager_3.3_R18-1_EN.pdf - 第100页

SIPLACE Feeder Ma nager 3.3 (R18 -1) / Getting S tarted 08/2018 Edition 100 Fig ure 9- 32 Feeder Bloc king Messag e as seen in Station GUI NOTE In Feeder M anager 3.1, the Enforce Fe eder Block functio n is only availabl…

SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition

Once enabled, if any feeder of the above mentioned status is inserted to online or offline

locations, depending on user configuration, Setup Center will indicate the blocked status as

below. Subsequent Setup Verification with the feeders in question will fail to proceed.

Figure 9-31 Feeder Blocking Message as seen in Setup Center GUI

For online station locations, if any Setup Verification attempt is made on such feeders, an

error message will be shown on the Station GUI to inform the user the reason of failed

verification as below.

SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition

100

Figure 9-32 Feeder Blocking Message as seen in Station GUI

NOTE

In Feeder Manager 3.1, the Enforce Feeder Block function is only available

when Setup Center is installed.

For online feeders which turn Overdue or being marked as Defective AFTER the starting of

production, there will be no warning / error issued by Feeder Manager until such feeders are

removed and inserted again. In other words, the checking of feeder blocking only happens

when problematic feeders or the COT that contains them are inserted.

In case when a feeder enters the defective, overdue status, if it is still within the Maintenance

Extension criteria defined by Feeder Manager, the user can still choose to extend its usage by

following the Maintenance Extension workflow. But once the extension is done, the feeder

must be removed and inserted again in order for the Blocked status to be reset. Otherwise the

Setup Verification will still fail on this feeder.

SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition

101

10 Help

The Help menu group seen from previous versions of Feeder Manager has been removed

because Feeder Manager is now a module inside ASM Studio, and all the corresponding

functions shall be accessed from the ASM Studio main menu.

10.1 Error reporting

Error reporting allows the user to start the ASM Net Error Reporter Services. With this

program the product installation can be selected for which an error report shall be generated.

To start, go to the ASM Studio main menu and select Error Reporting…

Figure 10-1 ASM Studio Error Reporting

Note: With the current version of ASM Studio, auto navigation to the error report profile for the

active module is not enabled. Therefore you need to manually locate the correct profile and

select it.

10.2 Online Help

Allows the user to open the Online Help file for the Feeder Manager.

Starting from Feeder Manager 3.0, the Online Help is incorporated into the main ASM Studio

Online Help. See below.