00198178-04_GS_FeederManager_3.3_R18-1_EN.pdf - 第46页

SIPLACE Feeder Ma nager 3.3 (R18 -1) / Getting S tarted 08/2018 Edition 46 2) Via the Action button of Feeder details. Open up a certain Fee der’s f eeder detail view, and the n press the Action butt on to bring up the d…

SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition

5.4.6 Step 6 – Summary

Figure 5-29 Feeder Maintenance Workflow Summary page

The 6

and last step gives you the summary of all the maintenance settings about to be

applied to the feeder.

Check the content to make sure they are correct. You can use the Back button to go to any

previous step for modifications.

Once satisfied, press the Complete & Store Data button to complete the maintenance

workflow for this feeder and store the relevant maintenance data into Feeder Manager

database.

5.5 Feeder Repair Workflow

Note: Feeder Repair workflow will be done in a guided way to avoid unwanted input errors.

The Feeder Repair Workflow can be accessed via two places

1) Via the main meu. Go to Feeder  Feeder Repair Workflow

Figure 5-30 Access Feeder Maintenance Workflow from the main menu

Note: You will need to key in or scan the feeder ID to be maintained.

SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition

2) Via the Action button of Feeder details.

Open up a certain Feeder’s feeder detail view, and then press the Action button to bring

up the dropdown list of actions. Select Feeder Repair Workflow.

Figure 5-31 Access Feeder Maintenance Workflow from the feeder detail view

Note: in this approach, the Feeder ID of the feeder selected will be pre-entered into the

first page of the Repair Workflow.

The feeder repair workflow will be started and follow the steps below.

5.5.1 Step 1 - Enter feeder information

The first step of the Feeder Repair flow is to request for Feeder ID and the Location this

feeder is to be assigned to for maintaining.

Figure 5-32 Feeder Maintenance Workflow Step 1

Note:

Feeder IDs can also be scanned by using a wired scanner connected to the PC,

see 5.1.1 Add New Feeder view and Feeder Console tab for details.

Feeder ID field will be pre-entered if this workflow is triggered from the Action

dropdown of a selected feeder.

Note:

For the first time this function is used, the Location ID field will be empty. Once a

maintenance location is selected, it will be used as the default maintenance location

for consequent maintenance and repair workflows, until it is changed

Press Next to continue.

SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition

5.5.2 Step 2 - Run SFTS or XFTS to check feeder

Figure 5-33 Run SFTS or XFTS to check feeder before maintain

This step provides an option for you to do feeder checking using either SFTS or XFTS

(depending on the feeder type) before proceeding to the repair procedure.

If you choose Yes, an SFTS verification should be done now. Feeder Manager will

automatically collect the feeder test result.

Once done, press Refresh button to have the test result displayed. Check the data and press

Next to proceed.

Or select No at the top of the form to continue without a feeder checking.

5.5.3 Step 3 – Repair Information

Figure 5-34 Repair information

This step allows you to enter the repair information. Refer to section 5.4.5 to details.