00198178-04_GS_FeederManager_3.3_R18-1_EN.pdf - 第132页
SIPLACE Feeder Ma nager 3.3 (R18 -1) / Getting S tarted 08/2018 Edition 132 14.3.2 X Feeder ID Association X feeders produced in early tim es may not indicate the f eeder ID on the vendor bar code. Feeder Manager can o b…
SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition
131
General tab
Scan a feeder barcode.
The feeder status for the scanned feeder is displayed.
Figure 14-12: Feeder status - green
By feeder status Available and maintenance status Normal, the status is indicated in green.
By feeder status Blocked and maintenance status Overdue, the status is indicated in red.
Figure 14-13: Feeder Status - red
By feeder status Available/In Use and maintenance status Due, the status is indicated in
orange.
Maintenance Details tab
Tap on this tab to display more maintenance details.
Tap on Menu – Close to exit the screen.
or
Tap on Menu – Clear Form to perform the function for another feeder.
SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition
132
14.3.2 X Feeder ID Association
X feeders produced in early times may not indicate the feeder ID on the vendor barcode.
Feeder Manager can obtain the feeders ID through EDIF communication when this type of
feeders are placed online or connected through docking station. But when the vendor barcode
is scanned, Feeder Manager will not be able to identify it correctly.
With the X Feeder ID association function, the user can associate an X-feeder’s vendor
barcode with its actual feeder ID by scanning the barcode (which is composed of its part
number and serial number), followed by the actual location (location barcode and track
barcode).
After the association is done, this feeder will be conveniently identified by its vendor barcode.
Warning: Use this function with caution.
1) This function is ONLY applicable to X feeders which has a valid EDIF
communication and with a vendor barcode like this,
Figure 14-14 Old X Feeder External Barcode Example
2) The user is strongly suggested to do the association outside of the production time.
3) In order to avoid any erroneous association, the user should insert the feeder into
EDIF communication right after scanning the vendor barcode.
4) The EDIF communication should also be maintained for the rest of the ID
association process.
Following are the steps for this operation.
Select X Feeder ID Association in the Main menu.
The following screen is displayed.
Figure 14-15: X Feeder ID Association
SIPLACE Feeder Manager 3.3 (R18-1) / Getting Started 08/2018 Edition
133
Scan the vendor label (item number and serial number) from the feeder.
The following screen is displayed, in which the feeder ID has been derived from the item
number and serial number.
Figure 14-16: X Feeder ID Association with Feeder ID
Scan the location barcode where this feeder is located.
The following screen is displayed, in which all feeders on the scanned location are displayed.
Figure 14-17: X Feeder ID Association with Location ID
Scan track ID barcode
The user will be prompted with following message.