00196625-03_AI_SX12_PCB_Barcode_de_en.pdf - 第154页
Setting up and Commissioning Installing the PCB Barcode Scanner Connecting the Barcode Scanne r to the SIPLACE SX 154 PCB Barcode LP-Barcode ► Run the cable under the conveyor side and through the cable duc t t o t h e b…
Setting up and Commissioning
Connecting the Barcode Scanner to the SIPLACE SX Installing the PCB Barcode Scanner
PCB Barcode LP-Barcode 153
Running the USB cable from the converter to the Box PC
► Connect the USB cable to the relevant connection on the converter and run the cable over the con-
veyor control cover towards the box PC (1).
Setting up and Commissioning
Installing the PCB Barcode Scanner Connecting the Barcode Scanner to the SIPLACE SX
154 PCB Barcode LP-Barcode
► Run the cable under the conveyor side and through the cable duct to the box PC (2 to 4). Make sure
that the cable is not in the hazard area of the gantry.
► Use cable ties to fix the cable to the other cables already present.
► Connect the cable to the unoccupied USB port on the box PC (5).
► Fit the cover on the cable duct (6).
See also
3.3.2.1.1 Installing the Barcode Scanner Software [ ➙ 177]
Setting up and Commissioning
Connecting the Barcode Scanner to the SIPLACE SX Installing the PCB Barcode Scanner
PCB Barcode LP-Barcode 155
3.2.7.2 Connecting the 2D PCB Barcode Scanner
Example: connection of 2D PCB barcode scanner to lane 1, top
Legend
► Connect each barcode scanner according to the wiring plan on the option board:
You can use the diagram on the inside of the conveyor control cover for help.
► Run the connection cable to the USB hub (0307 7944-W3) out of the conveyor control tray, at the
back left.
1 Connection X82 2 Connection X84
Conveyor lane Connections on relevant option board
Conveyor lane 1 top X82 and X84
Conveyor lane 2 top X82 and X84
Conveyor lane 1 bottom X81 and X83
Conveyor lane 2 bottom X81 and X83
WARNING
Handling the cable
Cables may only be connected to or disconnected from the machine when currentless.
The connector encoding informs the conveyor control that a scanner is to be used at the rele-
vant installation position. If the scanner is missing, an error message will be issued.
Please note that scanner cables may only be connected to the option board if the correspond-
ing scanner has been fitted.