YSD_Users_E.pdf - 第89页

2-29 2 Basic operation 3.6 Bleeding the nozzle air T o optimize the pressure in a syringe, the air in the nozzle must be bled out. Use the following procedure to dispense adhesi ve from the head to bleed the air . Do thi…

100%1 / 401
2-28
2
Basic operation
3
Press the [Start] button to start warm-up.
The warm-up progress time and status will appear under the "Progress Status".
Warm-up screen
64208-N7-00
c
CAUTION
If an abnormality occurs during warm-up, press the [Stop] button to stop operation immediately, check the cause of
the problem and eliminate it.
4
Finish the warm-up.
Warm-up will automatically stop when the warm-up time you set is reached. Press the [Close] button,
and return to the previous screen.
2-29
2
Basic operation
3.6 Bleeding the nozzle air
To optimize the pressure in a syringe, the air in the nozzle must be bled out.
Use the following procedure to dispense adhesive from the head to bleed the air. Do this just before starting
production.
c
CAUTION
When temperature setting is used, allow at least 15 minutes after installing the syringe before bleeding the air so that
the temperature of the temperature regulator unit is sufficiently transmitted to the syringe.
1
Press the [Cylinder exchange] button.
The “Cylinder exchange” window appears.
2
Move the head to the syringe replacement position.
Press the [Move default] button to move the head to the syringe replacement position.
TIP
You may press the emergency stop button and then move the head by hand to the syringe replacement position.
“Move axis” window
64205-N7-00
2-30
2
Basic operation
e
3
Open the safety cover.
1. After the head moves frontward, press the emergency stop button and open the safety cover.
2. Prepare a rag to use when dispensing adhesive.
4
Check how adhesive is dispensed.
1. Press the [Cylinder exchange] button on the Setup screen.
2. Place a rag beneath the head and press the [Blow] button for the applicable head.
3. Check that the adhesive is dispensed smoothly.
• After replacing the head or syringe, blow for a period long enough to bleed the air.
• Nozzles for Type111, 112, 114 will dispense adhesive 10 centimeters or more from the nozzle tip.
• Nozzles with large diameter holes other than the above will dispense adhesive approximately 5
centimeters from the nozzle tip.
“Cylinder exchange” window
“Blow” group box “Init Dispense” group box
64226-N7-00
Check for adhesive dispensing
Adhesive
Rag
63209-N7-00