CM602all_EJM8AESM_Service Manual.pdf - 第1003页

Tray kgs. 7 Min. 0 7-2-2 Direct Tray Pickup Position Teaching Removal/Disassembly 7 0 Nozzle 1003 Teaching Min. Min. Direct Tray • This section describes the procedures for teaching the direct tray pickup position. Total…

(1) Select the tray.

(2) Jig setting

Put Nozzle 1003 on Head 3.

(3) Height teach

(4) Position teach

(5) Jig remove

Remove the Nozzle 1003 from Head 3.

Installation is finished.

Adjust the feeder-reel-support height if

necessary. When adjusting the tape-feeder-reel-

support height, adjust the height with the

three positions shown at left.

To adjust the height, use these two

collars. Insert the collar between the

plate and the adjusting bolt, and adjust

the height.

Tray Direct Tray

Item

Nozzle 1003

Remark

Install the machine covers.

Teach (in Serviceman mode)

Machine parameter/Machine parameter teach

See 7-2-2. Pickup Position Teaching.

Remove the cover from the side shown

at left, and put it on the front.

Remove the cover,

and put it on the front.

EJM8A-E-SMA070201-A01-00

Page 7-2-1-7

Tray

kgs.

Min.

7-2-2 Direct Tray Pickup Position Teaching

Removal/Disassembly

Nozzle 1003

Teaching

Min. Min.

Direct Tray

• This section describes the procedures for teaching the direct tray pickup position.

Total Part Weight

Assembly/Adjustment

Tool

Jig

Min.

Caution

Danger

Warning

EJM8A-E-SMA070202-A01-00

Page 7-2-2-1

(1) Select [Tray feeder] from the

machine parameter teach menu. Press

[Jig setting].

(2) Turn off (O) the servo switch.

(3) Open the safety cover.

(4) Put Nozzle 1003 on Head 1.

(5) Close the safety cover.

(6) Turn on (I) the servo switch.

(7) Press [Height teach].

• Height teaching will be performed.

(8) Press [Position teach].

• Position teaching in the X and Y

directions will be performed.

Carry out machine parameter teaching.

Main menu/Machine parameter teach/Tray feeder

Height teaching

Position teaching