CM602all_EJM8AESM_Service Manual.pdf - 第514页
Remarks * Only when removing, take this step. Remove the laser board. Remove the multi-purpose nozzle See Sections "6-1-3. Adding a Lead Checker" See Section "6-2-3. Nozzle Changer Replacement (Multi- Purp…
Machinery Part Replacement
Z Unit (3-nozzle type)
RemarksItem
* Only when removing, take this step.
7
5
Do not move the dog.
Feeler gauge
See Section "6-2-5 3-Head
Support Regulator
Replacement."
See Sections "6-3-1.
Installing the Lead
Checker"
amplifier.
6
* Only when removing, take this step.
8
Remove the electropneumatic regulator.
Adjust the collision preventing photo sensor so that it turns ON when the gap of the
collision preventing stopper and the X beam is 0.5 mm.
Remove the lead checker sensor
sensor dog.
Precisely position the Y-axis interference Move it down to the other end of the cut.
0.5
Multi-purpose
High-speed
[Multi-purpose head]
[High-speed head]
Collision preventing
stopper
PH bracket
Dog
Dog
PH bracket
Collision preventing
stopper
0.5
EJM8A-E-SMA050504-A01-00
Page 5-5-4-3
Remarks
* Only when removing, take this step.Remove the laser board.
Remove the multi-purpose nozzle
See Sections "6-1-3.
Adding a Lead Checker"
See Section "6-2-3.
Nozzle Changer
Replacement (Multi-
Purpose Machines)."
Remove the cable.
* Only when removing, take this step.
changer.
Machinery Part Replacement
Z Unit (3-nozzle type)
Item
See Section "6-1-3.
Nozzle Changer
Replacement (High-speed
Machines)."
Install the high-speed nozzle changer.
10
11
9
12
CPUBOX
Multi-purpose head
High-speed head
Amplifier
Sensor
EJM8A-E-SMA050504-A01-00
Page 5-5-4-4
Machinery Part Replacement
Z Unit (3-nozzle type)
Check the basic parameters.
13
Switch on the power and air supply
.
From 0.49 Pa
To 0.54MPa
Change the system parameters
to "HighSpd head." according to the machine specifications.
Check the option parameters.
15
16
Change the setup of the desired stage
Change the system parameters.
RemarksItem
14
1
2
EJM8A-E-SMA050504-A01-00
Page 5-5-4-5