CM602all_EJM8AESM_Service Manual.pdf - 第826页
Remarks Component-Thickness-Measuring Unit Item Option Part and Accessory Replacement "End" (E: in red, nd: in green) setting Press the "Mode " button once again to display "End" (E: in red,…
Remarks
Component-Thickness-Measuring Unit
Item
Option Part and Accessory Replacement
Unlock the amplifier key.
Hold down the "Manual" and "Mode"
buttons for some seconds at the same
time.
"out 1 L-on" setting
Hold down the "Mode" button for two
seconds to display "out 1 L-on."
If "out 1 D-on" is displayed, press the
"Manual" button to change it to "out 1 L-
on."
"hsp" setting
If "FinE" is displayed when pressing the
"Mode" button once, press the "Manual"
button to change it to "hsp." (When "hsp"
is displayed, proceed to the next step.)
"End" (in green) setting
Press the "Mode" button once so that
"End" (in green) is displayed.
24
21
23
22
Manual button
Mode button
EJM8A-E-SMA060404-A01-00
Page 6-4-4-7
Remarks
Component-Thickness-Measuring Unit
Item
Option Part and Accessory Replacement
"End" (E: in red, nd: in green) setting
Press the "Mode " button once again to
display "End" (E: in red, nd: in green).
The initial display is returned.
Set the am
p
lifier out
p
ut t
yp
e "2."
Repeat Steps 22 to 25.
"out 1 L-on" setting
"hsp" setting
"End (in green) setting"
"End (E: in red, nd: in green) setting
Change the amplifier output type to "1."
27
28
25
26
Set the channel switch to "2."
Switch the channel to "1."
EJM8A-E-SMA060404-A01-00
Page 6-4-4-8
Remarks
Component-Thickness-Measuring Unit
Item
Option Part and Accessory Replacement
Set the output-1 threshold.
Press the "Manual" button until the value
becomes 1250.
Change the amplifier output type to "2."
Output-2 threshold setting
Press the "Manual" button until the value
becomes 2000.
Change the amplifier output type to "1."
32
29
30
31
Threshold
Switch the channel to "2."
Switch the channel to "1."
Threshold
EJM8A-E-SMA060404-A01-00
Page 6-4-4-9