CM602all_EJM8AESM_Service Manual.pdf - 第1036页

the bolt shown with the arrow below. Tray Rear Remark Turn off the power. Phillips screwdriver #2 Screw M4 4 to 6 pcs. Phillips screwdriver #2 Screw M4 14 pcs. Remove the bolt. Allen key 2 mm Phillips screwdriver #1 M3 6…

100%1 / 1093
kgs.
80
Tray
Min.
30
Part Weight
Tool
7-2-8
Torque wrench
Tension gauge
Teaching
Assembly/AdjustmentRemoval/Disassembly
10
Min. Min.
40
• This section describes the procedures for replacing the extension-axis timing belt.
Total
Extension-axis Timing Belt Replacement
Direct Tray
Jig
Jig: FM-1924
Pulley holding jig
Tension gauge
Min.
Caution
Danger
Warning
EJM8A-E-SMA070208-A01-00
Page 7-2-8-1
the bolt shown with the arrow below.
Tray
Rear
Remark
Turn off the power.
Phillips screwdriver #2
Screw M4 4 to 6 pcs.
Phillips screwdriver #2
Screw M4 14 pcs.
Remove the bolt.
Allen key 2 mm
Phillips screwdriver #1
M3 6 pcs.
Truss 6 pcs.
Open the cover.
Left. Stay at the front side when removing Right
Be careful not to drop the bolts.
3
2
1
Item
Direct Tray
Remove the cover.
4
Remove the four hexagon bolts, and then the palette table.
TP-axis
EJM8A-E-SMA070208-A01-00
Page 7-2-8-2
Put the belt in place. Tension the belt at
the motor section. Loosen B. Tension it
in the order of A and B.
Check Tensions F1 and F2 with a
tension gauge.
Tray
After replacing the belt, tighten the belt-
clamp section.
section. Loosen A.
Allen key 4 mm
Screw M5 2 pcs.
Remark
Tension gauge
F1 48.5+/-3Hz
F2 231 +/- 17Hz
Loosen the belt tension at the motor
Replace the belt.
Allen key 2.5 mm
Screw M3 2 pcs.
Remove the belt-clamp section.
6
7
8
Item
Direct Tray
Allen key 2.5 mm
Screw M3 2 pcs.
5
Belt clamp
Extension-axis motor
Supply
section
A
F1=48.5Hz
A
B
F2=231Hz
Supply
section
Supply
section
EJM8A-E-SMA070208-A01-00
Page 7-2-8-3