CM602all_EJM8AESM_Service Manual.pdf - 第143页
Maintenance Adjustment Main Body Beam Remarks Item Tighten the theta holding set screws. Allen key 1.5 mm Teach "Board Recognition Camera - X and Y-axis Origin Offset." For details, see Sections at right. High-…
Maintenance Adjustment Main Body Beam
Remarks
Item
Remove the
j
i
g
from the conve
y
or.
Move the head assembly to the steel rails.
Loosen the theta holding set screws.
Be careful not to let small brass bushings
fall off the screw holes.
Allen key 1.5 mm
Looking at the camera from above, Looking at the camera from above
turn the head camera unit clockwise. turn the head camera unit counterclockwise.
within +/- 0.2°
9
10
11
12
NG OK NG
No
screw
Loosen
EJM8A-E-SMA040102-A01-00
Page 4-1-2-4
Maintenance Adjustment Main Body Beam
Remarks
Item
Tighten the theta holding set screws.
Allen key 1.5 mm
Teach "Board Recognition Camera - X and Y-axis Origin Offset."
For details, see Sections at right. High-speed machine:
Section 4-2-2
Multi-purpose machine:
Section 4-3-2
Specifications:
within +/- 0.05°
Put back the feeder cover.
Phillips screwdriver #2
Screw M4 2 pcs.
15
14
13
Lightly
tighten
Lock
No
screw
ON
EJM8A-E-SMA040102-A01-00
Page 4-1-2-5
Maintenance Adjustment Main Body Beam
・Tools
Phillips screwdriver #2
Allen key 2.5 mm
Allen key 3 mm
Caliper 500 mm
Ruler 500 mm
・Jig
None
This section describes the procedures for adjusting the original width of the board transfer conveyor.
Remove the support pins beforehand.
4-1-3 Adjusting the Original Width of the Board Transfer Conveyor
Assembly
Adjustment
10min.
Teaching
min.
Total Time Weight of
Part
Removal
Disassembly
10min.
20min.
kgs
Caution
Dange
r
Warning
EJM8A-E-SMA040103-A01-00
Page 4-1-3-1