CM602all_EJM8AESM_Service Manual.pdf - 第807页
Remark Component-Thickness-Measuring Unit Option Part and Accessory Replacement Item Check the amplifier level. Block the light of the light-emitting sensor with the ND filter and check the amplifier level is 600 or more…
Remark
Component-Thickness-Measuring Unit
Option Part and Accessory Replacement
Item
* Since there are magnets, ensure safety
using a non-magnetic Allen keys when
working on the machine.
Bolts that come with the
cover (Large): 4 pcs.
Bolts that come with the
cover (Small): 2 pcs.
* Non-magnetic Allen key
Put the feeder cover back on.
67
Allen key 3 mm
Screw M4 4 pcs.
Turn on the power and air supply.
Remove the covers (Large) (Small) from the secondary part.
Remove the bubble wrap from the line sensor camera.
65
66
68
1
2
Bolts
(Large)
Cover (Small)
EJM8A-E-SMA060402-A01-01
Page 6-4-2-19
Remark
Component-Thickness-Measuring Unit
Option Part and Accessory Replacement
Item
Check the amplifier level.
Block the light of the light-emitting sensor
with the ND filter and check the amplifier
level is 600 or more. If it is less than 600,
re-adjust the sensor light-axis.
ND filter
N510013050AA
* Use the nozzle changer when fitting
the nozzles.
When the nozzle changer is not
mounted, fit the nozzles straight and
vertically, checking the nozzle
arrangement for the correct nozzles
* See Operation manual
5-5-2
A
d
j
ustment
Procedures for machine parameter
teaching
Z-axis origin offset Service manual 6-4-3
Fit the nozzles on the head using the nozzle changer.
70
71
69
ND filter
Amplifier level
EJM8A-E-SMA060402-A01-01
Page 6-4-2-20
• Tools
• Jigs
• This section describes the procedures for teaching after component-thickness-sensor reaplacement.
(12-nozzle head)
Option Part and Accessory Replacement
Component-Thickness-Measuring Unit
6-4-3 Machine Parameter Teaching Procedures (Z-axis origin offset)
* Before teaching, check no polarizing plates are attached to the head camera.
(5-11-6 Determining the Mounting Height and Positioning the Board, 5-11-7 XY Plane
Calibration, 5-11-8 Pickup Position and 5-11-10 Nozzle Exchange Position)
Notice
Before carrying out machine parameter teaching (Z-axis origin offset), save the current
machine parameters into a floppy disk. (Programming manual)
Dange
r
Warning
Caution
EJM8A-E-SMA060403-A01-00
Page 6-4-3-1