CM602all_EJM8AESM_Service Manual.pdf - 第577页
24 Put the side covers back on. 23 Connect the cart installation check sensor connector. 22 Remove the grease hose. Item Remarks 21 Secure the sensor cable with a cable tie. Nipper Machinery Part Replacement Feeder Cart …
20
Allen key 2.5 mm
Screw M3 4 pcs.
19
Remove the jig.
Remove the iron plate.
Allen key 3 mm
Iron plate
Magnetic stand
Dial gauge
Install the sensor.
Once the jig has been adjusted to parallel, adjust the right bracket so that it
18
Confirm the parallelism of the jig.
Tighten the bracket bolts completely.
Machinery Part Replacement Feeder Cart Installing Section
Item Remarks
17
is parallel with the Y-axis.
16.5㎜
EJM8A-E-SMA050802-A01-00
Page 5-8-2-6
24
Put the side covers back on.
23
Connect the cart installation check
sensor connector.
22
Remove the grease hose.
Item Remarks
21
Secure the sensor cable with a cable tie.
Nipper
Machinery Part Replacement Feeder Cart Installing Section
EJM8A-E-SMA050802-A01-00
Page 5-8-2-7
28
Switch on the power.
27
Put the feeder cover back on.
Phillips screwdriver #2
Screw M4 2 pcs.
26
Put the chute back on.
Allen key 3 mm
Screw M4 x 10mm 3 pcs.
Thick washer 3 pcs.
25
Put the feeder cover bracket back on.
Item Remarks
Feeder Cart Installing Section
Close the cover.
Tighten the left
and the right
screws.
EJM8A-E-SMA050802-A01-00
Page 5-8-2-8