CM602all_EJM8AESM_Service Manual.pdf - 第896页

7 8 Raise the lift axis. Once the adjustment is complete, Rotate the eccentric pins so that the Tray Shuttle Tray 6 Mount the jig on the lift. Remarks Item remove the jig. Phillips screwdriver #2 Allen key 3mm Screw M4 2…

100%1 / 1093
Leave both the upper and the
lower springs contracted.
2
1
Item
3
4
Allen key 3 mm
Phillips screwdriver #2
M4 x 8L 8 pcs.
M4 x 10L Truss 2 pcs.
Rotate the eccentric pin so that the spring remain contracted.
Tray Shuttle Tray
Open the side cover.
Remarks
Press [Return to origin].
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Remove the top cover.
EJM8A-E-SMA070103-A01-00
Page　7-1-3-2
7
8
Raise the lift axis.
Once the adjustment is complete,
Rotate the eccentric pins so that the
Tray Shuttle Tray
6
Mount the jig on the lift.
RemarksItem
remove the jig.
Phillips screwdriver #2
Allen key 3mm
Screw M4 2 pcs.
shaft is aligned with the jig as shown below:
5
Press the jig
against the
linear rails.
The shaft should touch the
j
ig slightly.
0
FM-0545
EJM8A-E-SMA070103-A01-00
Page　7-1-3-3
10
Tray
12
Phillips screwdriver #2
Allen key 3mm
Screw M4 2 pcs.
remove the jig.
Once the adjustment is complete,
11
Mount the jig on the lift.
Rotate the eccentric pins so that the
shaft is aligned with the jig as shown below:
Item Remarks
9
Raise the lift axis by 422 st.
Shuttle Tray
Press the jig against
the linear rails.
The shaft should
touch the jig
slightly.
EJM8A-E-SMA070103-A01-00
Page　7-1-3-4