CM602all_EJM8AESM_Service Manual.pdf - 第211页

Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles) Remarks Item Press [Unlock] and [ θ axis or g offset M g f power teach] simultaneousl y . The jig is recognized automatically so that the θ angle origin and…

100%1 / 1093
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Press [Chip recog camera
θaxis OriginOffset].
If "0" is displayed in the
"Magnifying power" boxes
shown at left, enter a
tentative value "0.01"
Press [Chip recog camera
θaxis OriginOffset.].
Select the stage to be taught.
Press [Unlock] and [Jig setting] simultaneously.
The head moves to the jig setting
position (the center of the stage).
Set the jig on Nozzle
Position 3.
1
Item
3
2
4
EJM8A-E-SMA040204-A01-00
Page　4-2-4-2
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Press [Unlock] and [θaxis or
g
offset M
g
f power teach] simultaneousl
y
.
The jig is recognized automatically so
that the θangle origin and the camera
magnification offsets are entered.
Select [Yes] or [No].
Press [Unlock] and [Angle teach] simultaneously.
Recognition is carried out automatically
so that the angle offset is entered.
If θ is 0.05 or larger, an
error will occur.
In this case, adjust the
chip recognition camera.
Refer to Section 4-1-1
"Chip Recognition
Camera Theta
Positioning."
Press [Unlock] and [Recog posn tch] simultaneously.
Recognition is carried out automatically
so that the recognition position offset is
entered.
* If the nozzle holder set screw faces you: Select [NO].
Recognition will start immediately.
* If the nozzle holder set screw faces opposite: Select [YES].
The nozzle holder will rotate 180° and recognition will be carried
out.
6
5
7
8
Be careful of position of set
screw.
EJM8A-E-SMA040204-A01-00
Page　4-2-4-3
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Move the jig from 3 to Nozzle 6.
Press [Unlock] and [Run] simultaneously.
Nozzle Position 6 is recognized and
taught automatically. The recognition
position offset will be entered.
Press [Unlock] and [Jig setting] simultaneously.
The head moves to the jig setting
position (over the NG box).
Set the jig.
Move the jig to Nozzle
Position 4.
9
10
11
12
EJM8A-E-SMA040204-A01-00
Page　4-2-4-4