CM602all_EJM8AESM_Service Manual.pdf - 第580页
Machinery Part Replacement Remarks Switch off the main power and air supply. 0.00MPa Remove the feeder cover and the chute. Phillips screwdriver #2 Allen key 3 mm Screw M4 2 pcs. Screw M4x10 3 pcs. Thick washer 3 pcs. Re…
Machinery Part Replacement
This section describes the procedures for replacing the cutter blades.
・Tools
Phillips screwdriver #2
Allen key 3 mm
Allen key 4 mm
Feeler gauge
・Jig
None
Cutting Unit
Be very careful not to get your hand cut.
5-9-1 Cutter Blade Replacement
Cuttin
g
Unit
5-9
Assembly
Adjustment
15min.
Teaching
min.
Total Time Weight of
Part
Removal
Disassembly
15min.
30min.
4kgs
Caution
Dange
r
Warning
EJM8A-E-SMA050901-A01-00
Page 5-9-1-1
Machinery Part Replacement
Remarks
Switch off the main power and air supply.
0.00MPa
Remove the feeder cover and the chute.
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Screw M4x10 3 pcs.
Thick washer 3 pcs.
Remove the top safety cover.
6-000102
Phillips screwdriver #2
Screw M4 5 pcs.
Remove the fixed cutter blade.
6-000118
Danger: Be careful not to get your hand
cut.
If the fixed cutter blade only is replaced,
proceed to Step 8.
Allen key 4 mm
Screw M5 9 pcs.
Cutting Unit
Item
2
3
4
1
1
2
EJM8A-E-SMA050901-A01-00
Page 5-9-1-2
Machinery Part Replacement
Remarks
Cutting Unit
Item
Remove the bar.
Allen key 3 mm
Screw M4 2 pcs.
Replace the movable cutter blade.
Danger: Be careful not to get your hand
cut.
Allen key 4 mm
Screw M5 9 pcs.
Put the bar back on.
Adjust the clearance from the movable
cutter blade and the bar.
Specification
Clearance:
0.05 mm to 0.2 mm
Place the fixed cutter blade in position.
6-000118
Allen key 4 mm
Screw M5 9 pcs.
8
7
5
6
0.05 mm to 0.2 mm
0.05-mm feeler gauge should pass
through; 0.2-mm one should NOT
be inserted.
EJM8A-E-SMA050901-A01-00
Page 5-9-1-3