CM602all_EJM8AESM_Service Manual.pdf - 第512页
Machinery Part Replacement Z Unit (3-nozzle type) Remarks 3 4 Install the high-speed head Remove the stopper block. See "Section 5-5-1. Replacing a Set of Head Units." BLOCK ： KXFB02KDA00 2 pcs. See Section &qu…
180180
Machinery Part Replacement
Z Unit (3-nozzle type)
See each procedures.
Phillips screwdriver #2
Phillips screwdriver #1
Volume adjusting
screwdriver
Allen key 3 mm
Allen key 4 mm
Iron plate
Dial gauge
Magnetic stand
Feeler gauge
• This section describes the procedures for changing the multi-purpose head to the high-speed one.
5-5-4 Head Change (Multi-purpose type ⇒ High-speed type)
Assembly/AdjustmentRemoval/Disassembly
Total Time Part Weight
Teaching
min. kgs600 min.min.240 10 max.min.
• Tools
• Jigs
Dange
r
Warning
Caution
EJM8A-E-SMA050504-A01-00
Page 5-5-4-1
Machinery Part Replacement
Z Unit (3-nozzle type)
Remarks
3
4
Install the high-speed head
Remove the stopper block.
See "Section 5-5-1.
Replacing a Set of Head
Units."
BLOCK：KXFB02KDA00
2 pcs.
See Section "5-3-1
Transfer Head Assembly
Replacement"
2
1
head.
Item
Remove the multi-purpose
Switch off the power and air supply.
1
2
Multi-purpose head
High-speed head
EJM8A-E-SMA050504-A01-00
Page 5-5-4-2
Machinery Part Replacement
Z Unit (3-nozzle type)
RemarksItem
* Only when removing, take this step.
7
5
Do not move the dog.
Feeler gauge
See Section "6-2-5 3-Head
Support Regulator
Replacement."
See Sections "6-3-1.
Installing the Lead
Checker"
amplifier.
6
* Only when removing, take this step.
8
Remove the electropneumatic regulator.
Adjust the collision preventing photo sensor so that it turns ON when the gap of the
collision preventing stopper and the X beam is 0.5 mm.
Remove the lead checker sensor
sensor dog.
Precisely position the Y-axis interference Move it down to the other end of the cut.
0.5
Multi-purpose
High-speed
[Multi-purpose head]
[High-speed head]
Collision preventing
stopper
PH bracket
Dog
Dog
PH bracket
Collision preventing
stopper
0.5
EJM8A-E-SMA050504-A01-00
Page 5-5-4-3