CM602all_EJM8AESM_Service Manual.pdf - 第903页
Tray Shuttle Tray 10 11 12 Enter the measured value into [TL] manually. Specifications: ±1.0 mm or less Tighten the lift-axis motor coupling. Specifications: Tightening torque: 8.0N ・ m A=2mm±1mm Allen key 5mm Ruler 150m…
Lift will Fall!
When the coupling is loosened, the lift
will fall down. To avoid this, hold the
ball screw with a wrench.
6
7
8
If the difference is more than ± 1mm,
Tray Shuttle Tray
RemarksItem
Reference: Jig on the replenishment table.
Specifications:
±1.0mm or less
When the difference in
height between the lift and
the replenishment tables is
+/- 1.0 mm or less,
proceed to Step 12 and
enter the parameter.
Measure the height of the jigs.
5
Allen key 3 mm
Screw M4 4 pcs.
Allen key 4 mm
Wrench 14 mm
Screw M5 6 pcs.
remove the coupling.
Holding the ball screw with a wrench,
Philips screwdriver #2
Screw M4 12 pcs.
open the cover.
Remove the ball screw cover.
Replenishment
table
Lift table
If the cover cannot be
removed
,
hold here.
EJM8A-E-SMA070104-A01-00
Page 7-1-4-3
Tray Shuttle Tray
10
11
12
Enter the measured value into [TL] manually.
Specifications:
±1.0 mm or less
Tighten the lift-axis motor coupling.
Specifications:
Tightening torque:
8.0N・m
A=2mm±1mm
Allen key 5mm
Ruler 150mm
M6 6 pcs.
After tightening the coupling, confirm the height.
Item Remarks
9
Measure the height of the jig.
Specifications:
±1.0 mm or less
Adjust the height of the lift table, turning the wrench.
A
To
l
o
w
e
r
To
raise
Wrench
+
-
EJM8A-E-SMA070104-A01-00
Page 7-1-4-4
• Jigs
30
• Tools
None
Phillips screwdriver #2
Precision screwdriver
Nipper
Allen key M4
Teaching
Assembly/AdjustmentRemoval/Disassembly
Lift-axis Driver Replacement
Min.
20 Min.
2.050
0
Min.
kgs
Tray
Min.
Shuttle Tray
This section describes the procedures for replacing the lift-axis driver.
Total Time Part Weight
7-1-5
Dange
r
Warning
Caution
EJM8A-E-SMA070105-A01-00
Page 7-1-5-1