CM602all_EJM8AESM_Service Manual.pdf - 第368页

Machine Part Replacement Main Body 24 Remove the Z clamp plates from the conveyor. Allen key 3 mm Special screw M4 x 8 16 pcs. 23 Put the head back on. For High-Speed Head, see Section 5-3-1 "Transfer Head Assembly …

100%1 / 1093
Machine Part Replacement Main Body
Allen key 3 mm
Allen key 4 mm
Screw M4 x 12 16 pcs.
Small flat round M4
16 pcs.
Screw M5 2 pcs.
Specifications:
Straightness:
0.015 mm or less
Tightening torque:
3.53 N.m
Magnetic stand
Dial gauge
Allen key 3 mm
Screw M4 x 18 13 pcs.
20
Place the iron plate on the plate so that
Iron plate holding the
magnetic stand
Allen key 3 mm
Screw M4 1 pc.
the magnetic iron can be placed on the plate.
19
Connect the grease hoses.
Allen key 3 mm
Screw M4 4 pcs.
18
Fit the plate, pressing the dowel pins on the back of the plate against the slider.
項目(ITEM) 備考(REMARK)
17
Tighten the linear rail holding bolts.
Check the straightness of the linear rail.
Dowel pins
Back of Head Plate
EJM8A-E-SMA050109-A01-00
Page　5-1-9-6
Machine Part Replacement Main Body
24
Remove the Z clamp plates from the
conveyor.
Allen key 3 mm
Special screw M4 x 8
16 pcs.
23
Put the head back on.
For High-Speed Head, see
Section 5-3-1
"Transfer Head Assembly
Replacement."
For Multi-Purpose Head,
see Section 5-5-2
"Replacing a Set of Head
Units."
22
Remove the straight edge from the Remove the iron plate on which the
Y-axis linear rail. magnetic stand is placed.
Straight edge 1500 mm
Iron plate holding the
magnetic stand
Allen key 3 mm
Screw M4 1 pc.
21
After placing the head plate, measure the
Specifications:
Parallelism of whole length
of the linear rail: 0.02 mm
or less
Z: 0.005 mm or less
Magnetic stand
Dial gauge
parallelism of the specified section of the straight edge.
項目(ITEM) 備考(REMARK)
340 mm
430 mm
Z: Parallelism when the dowel pin is moved
from the rightmost end by 340mm and 430 mm.
105 mm
Z
2.7 mm
EJM8A-E-SMA050109-A01-00
Page　5-1-9-7
28
Check the position of the head camera.
See Section 4-1-2 "Head
Camera Adjustment ---
Focus and Theta."
See Section 4-1-6 "Leveling
the Support Plate."
27
Switch on the power and the air supply.
From 0.49MPa
to 0.54MPa
25
26
項目(ITEM) 備考(REMARK)
Machine Part Replacement Main Body
Check the parallelism of the board
transfer conveyor.
See Section 4-1-
4"Parallelism of Board
Transfer Conveyors
Check the levelness of the support plate.
1
2
EJM8A-E-SMA050109-A01-00
Page　5-1-9-8