Smart Graphical User Interface (SmartG) Overview_rev1.pdf - 第71页

Machine Setting (Lighting Calibration)

User can enable/disable to

set the duration of lighting

calibration

Shows the last date and time for

lighting calibration

Shows when next date and time for

lighting calibration

To set the specific date

and time to perform

lighting calibration.

To set the limit XY for

board and width of grey

card position

User can customize log file whether

path/foldername/starting log file

Figure 61: Lighting Calibration Configuration

Machine Setting (Machine I/O)

*Please refer to the next slide to see input/output of each description and function

Figure 62: Content in Machine I/O

Emergency Stop Indicates whether the machine is in Emergency Stop.

Board Present Rail 1 Indicates that a board is clamped and ready for inspection in Rail 1 (Rail 2). Only one of

these inputs will be active at a time - if the other rail receives a board, the input will be

queued by the PLC until the current inspection is complete.

Board Present Rail 2 Indicates that a board is clamped and ready for inspection in Rail 1 (Rail 2). Only one of

these inputs will be active at a time - if the other rail receives a board, the input will be

queued by the PLC until the current inspection is complete.

HW Passthru Rail 1 (Rail 2) Indicates that the conveyor rail has been switched to pass through by the switch on the

front of the machine.

Air Pressure Normally On - Indicates that there is sufficient air pressure - If this becomes inactive

inspection will cease and an error message is displayed.

Maintenance The conveyor width is being adjusted.

AWA Moving The conveyor width is being adjusted.

Conveyor In Use Indicates there is a board in the machine - so AWA cannot be used

AWA Calibrating Indicates AWA process in progress

AWA Axis Homing Indicates AWA process in progress

Rail 1 (Rail2) Busy Indicates that a board is somewhere in the named conveyor - so machine busy for

upstream SMEMA

Table 1: Machine I/O Description