00198320-02_UM_ShuttleExtension-DE-EN-ZH.pdf - 第139页

Assembly and Instruction Manual 3 Assembly on the SIPLACE TX Shuttle Extension Edition 11/2018 3. 3 Assembly kit and mechanical connection 41 General 3  Remove the four side covers from the shuttle extension. This gi ve…

3 Assembly on the SIPLACE TX Assembly and Instruction Manual

3.3 Assembly kit and mechanical connection Shuttle Extension Edition 11/2018

3.3.1 Mechanical installation procedure

Intermediate ledges on SIPLACE TX output conveyor side 3

 Fit the two intermediate ledges to the machine feet of the SIPLACE TX output conveyor side.

Fig. 3.3 - 2 Intermediate ledge - right side

Fig. 3.3 - 3 Intermediate ledges -left side

(1) Intermediate ledge input conveyor - right side

(2) Intermediate ledge input conveyor - left side

(1)

(2)

Assembly and Instruction Manual 3 Assembly on the SIPLACE TX

Shuttle Extension Edition 11/2018 3.3 Assembly kit and mechanical connection

General 3

 Remove the four side covers from the shuttle extension. This gives you access to the fixtures

for the interface brackets and the electrical connection.

 Move the shuttle extension to the SIPLACE TX.

 Set the height of the shuttle extension, so that the PCB conveyor for the shuttle extension is

the same height as the PCB conveyor for the SIPLACE TX.

The shuttle extension stands on 4 feet.

Fig. 3.3 - 4 Presetting the height of the machine feet

(1) Top screw nut

(2) Bottom screw nut

(3) shuttle extensions feet

 Turn the shuttle extension feet (3) with the bottom screw nut (2) so that the shuttle extension

has the PCB conveyor height of the SIPLACE TX.

 Tighten the top screw nut (1), so that the machine feet are fixed into place.

 Check the height of the shuttle extension and correct the height, if necessary.

(1)

(2)

(3)

3 Assembly on the SIPLACE TX Assembly and Instruction Manual

3.3 Assembly kit and mechanical connection Shuttle Extension Edition 11/2018

Adjustment 3

 Place a machine spirit level (measuring accuracy of 0.02 mm) against the edge of the shuttle

extension PCB conveyor.

Fig. 3.3 - 5 Machine spirit level measuring accuracy of 0.02 mm) on conveyor rail

 Use the machine spirit level (1) to align the shuttle extension in the X and Y direction, at the

four machine feet.

 Unscrew the top nut (item 1 in fig. 3.3 - 4, page 41) with the help of an open-ended wrench.

 Use the open-ended wrench to set the bottom nuts (item 2 in fig. 3.3 - 4, page 41) of all four

shuttle extension feet, so that the fluid in the machine spirit level does not deviate from its

zero point at the required conveyor height.

 Check the required board conveyor height.

 Tighten the top nuts (item 1 in fig. 3.3 - 4, page 41) to clamp all shuttle extension feet.

(1)