00198320-02_UM_ShuttleExtension-DE-EN-ZH.pdf - 第141页
Assembly and Instruction Manual 3 Assembly on the SIPLACE TX Shuttle Extension Edition 11/2018 3. 3 Assembly kit and mechanical connection 43 Shuttle extension to SIPLACE TX alignment 3 Fig. 3.3 - 6 Alignment posit ion f…
3 Assembly on the SIPLACE TX Assembly and Instruction Manual
3.3 Assembly kit and mechanical connection Shuttle Extension Edition 11/2018
42
Adjustment 3
Place a machine spirit level (measuring accuracy of 0.02 mm) against the edge of the shuttle
extension PCB conveyor.
Fig. 3.3 - 5 Machine spirit level measuring accuracy of 0.02 mm) on conveyor rail
Use the machine spirit level (1) to align the shuttle extension in the X and Y direction, at the
four machine feet.
Unscrew the top nut (item 1 in fig. 3.3 - 4, page 41) with the help of an open-ended wrench.
Use the open-ended wrench to set the bottom nuts (item 2 in fig. 3.3 - 4, page 41) of all four
shuttle extension feet, so that the fluid in the machine spirit level does not deviate from its
zero point at the required conveyor height.
Check the required board conveyor height.
Tighten the top nuts (item 1 in fig. 3.3 - 4, page 41) to clamp all shuttle extension feet.
(1)
Assembly and Instruction Manual 3 Assembly on the SIPLACE TX
Shuttle Extension Edition 11/2018 3.3 Assembly kit and mechanical connection
43
Shuttle extension to SIPLACE TX alignment 3
Fig. 3.3 - 6 Alignment position for shuttle extension
Shuttle conveyor rails to be positioned at 281 (1mm gap on each outer end) and fixed with
motor brake.
Align one of the shuttle conveyor rails (either left or right) to TX conveyor rail.
Fig. 3.3 - 7 Check PCB
Check rail position with the calibrated PCB.
Push a board through the PCB conveyor and check the transition point between the shuttle
extension and the SIPLACE TX.
(1)
3 Assembly on the SIPLACE TX Assembly and Instruction Manual
3.3 Assembly kit and mechanical connection Shuttle Extension Edition 11/2018
44
It must be possible to push the board through easily and with no resistance.
Screw the shuttle extension onto TX machine via interface brackets to secure in place.
Interface brackets on input shuttle extension side 3
Fig. 3.3 - 8 Interface bracket on input conveyor - right side
Fig. 3.3 - 9 Interface bracket on input conveyor - left side
(1) Interface bracket input conveyor - right side
(2) Interface bracket input conveyor - left side
(1)
(2)