SL940-Install-Ops-Maintenance-7210918_B.pdf - 第113页
Configuration a nd C haract erization 6- 5 6.5 Cam era Confi guration NOTE ECXP is con figure d at th e factory for your parti cular c oating sy stem . If y ou should need to reconfigure the cam era, f ollow the steps …
6-4 Configuration and Characterization
4. Select Configure > Reconfigure from the ECXP Edit Screen.
The Configure Dialog Box (Figure 6-3) opens.
Figure 6-3 ECXP Configure Dialog Box
5. Select the item to be configured by clicking on it.
NOTE To select more than one item, hold down the <Ctrl> key while selecting
additional items.
6. When you are finished, click on
OK.
The software must be restarted in order to perform the configuration.
7. To close the ECXP Edit Screen and return to the Operator Screen, click on
or select
File > Exit from the menu bar.
8. To exit ECXP, click on
or select File > Exit from the Operator Screen menu bar.
9. Restart ECXP to perform the configuration procedure. ECXP will prompt you to answer a
series of questions defining your system configuration.
NOTE Prompts will vary depending on the items selected and answers to previous
prompts.
10. After you have responded to all the prompts, the ECXP program will start.
NOTE ECXP menu choices may vary depending on the answers to the prompts. Refer to
the Easy Coat User Guide for detailed instructions.
Configuration and Characterization 6-5
6.5 Camera Configuration
NOTE ECXP is configured at the factory for your particular coating system. If you should need
to reconfigure the camera, follow the steps below.
To configure the Genie Camera:
1. Select
Configure > Reconfigure from the ECXP Edit Screen.
2. When prompted to select the item to be reconfigured (Figure 6-4), select
Tools and click OK.
Figure 6-4 Reconfiguring ECXP Tools
3. Restart the ECXP software. When prompted to select an applicator:
a. Select
Genie Camera.
b. Press the <
Ctrl> key and select the appropriate coating applicator (Figure 6-5) and then
click
OK.
Figure 6-5 Configuring ECXP for the Genie Camera
4. After you have responded to all the on-screen prompts, the ECXP program will start.
6-6 Configuration and Characterization
6.6 Beacon Configuration
The behavior of the Light Beacon can be customized to respond to the I/O states of customer equipment
added to the system. Beacon Configuration is only turned on if both Custom System and Configurable
Beacon option are chosen during initial system configuration or reconfiguration. A separate beacon.ini
file is used to store the beacon configuration settings. The operation of the beacon depends on the
machine firmware. Some versions of the firmware may have priority over the beacon function.
NOTE ECW only monitors inputs and outputs when it is not busy running a product program or
procedure. If an input or output should change state during production, the beacon will
not be turned on until the current program or procedure is completed.
To set Beacon Configuration:
1. Configure the system as Custom. See 6.4.2 ECXP Reconfiguration.
Alternatively, you may edit the ECW.ini file. Find the [Workcell1] section and set
Has Configurable Beacon=1.
2. Decide what components you want to monitor.
You must know the I/O number for each of the components.
3. Create a Log Trigger Fault.
a. Click on
Configure > Status Monitoring > Log Trigger Fault.
b. Click on
New to add a new Trigger Fault (Figure 6-6).
Figure 6-6 Log Trigger Faults Dialog Box
c. Click on the Fault Message field and type in a short fault message.
This message will be displayed on the Fault Monitor.