SL940-Install-Ops-Maintenance-7210918_B.pdf - 第174页
在线预览 SL940-Install-Ops-Maintenance-7210918_B.pdf PDF 文档。
Appendix A - Material Safety Information A-9
Product Name: Moly-Graph® Extreme Pressure Multi-Purpose Lithium Grease
Product Number (s): SL3141, SL3144, SL3145, SL3146, SL3330, 8SL3141
State Regulations
California Safe Drinking Water and Toxic Enforcement Act (Prop 65)
:
This product may contain the following chemicals known to the state of
California to cause cancer, birth defects or other reproductive harm:
None
State Right to Know
:
New Jersey:
1317-33-5
Pennsylvania:
7782-42-5
Massachusetts:
1317-33-5, 7782-5
Rhode Island:
7782-42-5
Additional Regulatory Information:
None
Section 16: Other Information
NFPA
Health: 1
Flammability: 1
Reactivity: 0
HMIS
Health: 1
Flammability: 1
Reactivity: 0
PPE: B
Prepared By:
CRC#:
Revision Date:
Michelle Rudnick
2127
04/23/2007
Changes since last revision: Spanish part number added
The information contained in this document applies to this specific material as supplied. It may not be
valid for this material if it is used in combination with any other materials. This information is accurate to
the best of CRC Industries' knowledge or obtained from sources believed by CRC to be accurate. Before
using any product, read all warnings and directions on the label.
CAS:
Chemical Abstract Service
NA:
Not Applicable
ppm:
Parts per Million
ND:
Not Determined
TCC:
Tag Closed Cup
NE:
Not Established
PMCC:
Pensky-Martens Closed Cup
g/L
Grams per Liter
PPE:
Personal Protection Equipment
lbs./gal:
pounds per gallon
TWA:
Time Weighted Average
STEL:
Short Term Exposure Limit
OSHA:
Occupational Safety and Health Administration
COC:
Cleveland Open Cup
ACGIH:
American Association of Governmental Industrial Hygienists
NIOSH
National Institute of Occupational Safety & Health
mppcf:
Millions of particles per cubic foot (of air)
Appendix B - Block Diagrams B-1
Appendix B Block Diagrams
Table B-1 describes available pneumatic and electrical block diagrams and coating system electronics that may
help in understanding coating system operation and aid in troubleshooting.
B.1 Safety First
Use of engineering drawings to disassemble, service, and reassemble the coating system promotes good safety
practices only when used in conjunction with the precautions in Section 2 - Safety and other sections of this
manual.
CAUTION! Only service technicians should perform troubleshooting, servicing, and parts
replacement.
B.2 List of Electrical and Pneumatic Diagrams
Laminated 11" x 17" versions of diagrams referenced in Table B-1 are included with the coating system.
Table B-1 Block Diagrams
Drawing Number Title
7208942BD Electrical Diagram, Select Coat Series SL-940E
7208943PD Pneumatic Diagram, Select Coat Series SL-940E