SL940-Install-Ops-Maintenance-7210918_B.pdf - 第51页

Insta llat ion 3-1 3 Inst allation 3.1 Overvi ew Thi s sect ion describes installation pr ocedures fo r the Se lect C oa t SL -940E /SL-941E S eries Con formal Coating System and cov ers the following topics: • Uncrating…

Installation 3-1

3 Installation

3.1 Overview

This section describes installation procedures for the Select Coat SL-940E/SL-941E Series Conformal

Coating System and covers the following topics:

• Uncrating and Placing the Coating System

• Unpacking the Coating Area

• Leveling the Coating System

• Installing the Light Beacon

• Installing the Laptop Computer

• Installing the Optional Genie Camera

• Anchoring the Coating System

3.2 Safety First

Operation of your SL-940E/SL-941E Series Conformal Coating System involves heat, air pressure,

electrical power, mechanical devices, and the use of hazardous materials. It is essential that every person

servicing or operating the coating system fully understands all hazards, risks, and safety precautions.

Refer to Section 2 - Safety for additional information.

WARNING! CAUTION!

To ensure optimal performance and safety, it is necessary to install the coating

system in a facility that meets the necessary requirements listed in Section 10 -

Specifications. If you have any questions, please contact Asymtek Technical

Support.

3.3 Uncrating and Placing the Coating System

Tools and Materials Needed:

•

1/2 inch wrench

•

Band Cutter

•

9/16 inch wrench

•

Phillips Screwdriver (included in tool kit)

•

Personal Protective Equipment •

1 ½-inch wrench (included in tool kit)

•

Hammer

•

Forklift

•

Flat Bar •

Level

WARNING! CAUTION!

Installation procedures should only be performed by a trained service technician.

3-2 Installation

To uncrate and place the coating system:

1. Check the “Tip & Tell” and "Shockwatch" devices, both on the outside of the shipping crate

and on the coating system, to make sure that the coating system has not been dropped or

tipped. If any of these devices has been activated, contact Asymtek.

2. Locate and remove the envelope on the outside of the shipping crate. Open the envelope and

locate the shipping list.

 As you unpack each item inside of the box, identify the item, locate it on the shipping list,

and place a checkmark next to the item.

3. Referring to the uncrating instruction sheet, use the flat bar and hammer to remove the lid and

sides of the crate.

WARNING! CAUTION!

Personnel should wear gloves and safety glasses while removing the top and

sides of the crate. Sufficient personnel should be used to lift and control the crate

to prevent serious injury to personnel or damage to the coating system.

4. Remove the four machine-to-crate shipping brackets attached to the pallet using a 1/2-inch

wrench and 9/16-inch wrench (not provided).

5. Remove the two 1/2-inch hex head screws clamping the four shipping brackets to the

levelers.

Item Description Item Description

1 Foot Restraint Bracket 5 Lag Bolts and Washers

2 Hex Head Screws and Washers 6 Hex Nuts and Washers

3 Leveler (foot) 7 Post Nut

4 Machine-to-Crate Shipping Bracket 8 Lock Nut

Figure 3-1 Removing the Shipping Brackets