编带机说明书-含图纸ttm402.pdf - 第162页
7-6 TM-403 User’s Guide System Alarm Messages D292105.9b.fm System Alarm Messa ges During TM-402 operation, the operator will occasionally be promp ted to fill the Tr a y Feeder with pa rts, unload the T aper or check an…
D292105.9b.fm Emergency Stop
Chapter 7: Troubleshooting 7-5
8. Once homing is complete, press the Left Arrow button will open the Run Tab.
9. Press the Run button on the HMI Run Tab to resume operation.
7-6 TM-403 User’s Guide
System Alarm Messages D292105.9b.fm
System Alarm Messages
During TM-402 operation, the operator will occasionally be prompted to fill the Tray
Feeder with parts, unload the Taper or check an Inspection Fail.
When the TM-402 requires attention it will automatically stop. A beep will sound
and the Tower Light will turn flashing red to draw the operator’s attention.
On the HMI, a System Alarm Message will appear.
System Alarms are triggered for several reasons. When the TM-402’s sensors detect an error sit-
uation such as Low Cover Tape or a Tape Jam, the System Alarm Message alerts the user to the
error. System Alarms will also appear if the TM-402 needs to be adjusted before operation can
begin. For example, if the E-Stop button is depressed preventing operation, the System Alarm
alerts the user so the situation can be resolved and operation can begin.
System Alarm Messages contain a description of the problem and suggestions for resolving the
problem. They also include an illustration of the TM-402 with the area of interest indicated by a
flashing red outline.
To resolve a System Alarm, follow the suggested steps to clear the error situation then click Con-
tinue to return to the HMI screen that was active before the alarm was activated. To resume
operation, press Start on the HMI Run Tab.
D292105.9b.fm System Alarm Messages
Chapter 7: Troubleshooting 7-7
Note: There are a variety of error conditions which could cause the machine to stop. See
the Error Message Table at the end of this section for an explanation of the various error
messages and their suggested solutions.
An illustration and description of each System Alarm Message follows.
Part Not Picked System Alarm
If the nozzle is unable to pick a part from the Bowl Feeder, the Part Not Picked system alarm will
be activated. When this happens, operation stops, a beep sounds, and a warning appears on the
HMI.
To clear the Unable to Pick Alarm, ensure there are parts in the bowl and it is feeding properly
with no jams in the feeding track. If that does not resolve the problem, ensure the Pick Height is
not set too high. Finally, verify the Vibratory is Enabled.
When the Bowl Feeder is ready for operation, press CONTINUE to clear the alarm and resume
operation.