编带机说明书-含图纸ttm402.pdf - 第28页
1-8 TM-403 User’s Guide Assembling the TM-402 D292105.4a.fm Re-assemble the TM-402 1. Position the T ower Light Lift T ower Light, snapping it in place in an upright position perpendicular t o the TM-402. 2. Connecting t…
D292105.4a.fm Assembling the TM-402
Chapter 1: Assembly & Installation 1- 7
3. Remove the TM-402 from the Crate.
a. The TM-402 is bolted to the bottom of the crate for shipping. Reach below the crate to
unfasten the bolts.
Note: If the optional 80/20 Frame was purchased, follow the assembly instructions in the
80/20 Frame Exploded Views document which can be found in the Exploded Views sec-
tion at the end of this manual before proceeding.
b. Moving the TM-402 Base Machine. The machine may be manually lifted from the
crate. The base machine weighs 265 lb. (120 Kg) so the task will require four people.
Position one person at each corner of the machine using the lift points illustrated above to
safely distribute the machine’s weight. Lift the machine from the crate and place it onto
the prepared work table/bench.
4. Position the TM-402 in the work area so there is at least 3 feet of clearance on all sides.
(See the Preparing the Work Area section earlier in this chapter for details.)
5. The TM-402 is shipped with zip ties securing the pick head, the 2D Camera and any
mobile portions of the machine. Cut and remove all zip ties.
Lift Points
1-8 TM-403 User’s Guide
Assembling the TM-402 D292105.4a.fm
Re-assemble the TM-402
1. Position the Tower Light
Lift Tower Light, snapping it in place in an upright position perpendicular to the TM-402.
2. Connecting the Carrier Tape Arm
a. Remove the black knob from the right side of the Track Support Bracket.
D292105.4a.fm Assembling the TM-402
Chapter 1: Assembly & Installation 1- 9
b. The Carrier Tape Arm has a dowel pin which locks into position holes on the Track
Support Bracket. Slide the Carrier Tape Arm onto the threaded rod, engage the dowel pin
into the desired position, and secure it into place with the black knob.
4. Positioning the Take-up Arm
a. The Take-up Arm has a dowel pin which
locks into position holes on the Track Sup-
port Bracket. Loosen the black knob on the
back of the Take-up Arm and position it at
about a 45 degree angle from the baseplate
assembly. Engage the dowel pin into the
desired position and secure it into place with
the black knob..
b. Plug the electrical connector into the
take-up motor receptacle.
Position Holes
Knob