编带机说明书-含图纸ttm402.pdf - 第27页
D292105.4a.fm Assembling the TM-40 2 Chapter 1: Assembly & Installation 1- 7 3. Remove the TM-402 from the Crate. a. The TM-402 is bolted to the bottom of the crate for shipping. Reach below the crate to unfasten the…
1-6 TM-403 User’s Guide
Assembling the TM-402 D292105.4a.fm
Assembling the TM-402
Equipment Required
• Adjustable wrench (needs to fit 1 1/16” to 1 3/32” nut)
• Standard and Metric Hex Wrench Sets (provided with machine)
• 85-110 PSI air pressure system
Note: Read the TM-402 User’s Guide before assembling the TM-402.
Unpack the TM-402 Crate
1. Move the Crate to the Work Area. Use a fork lift to move the TM-402 crate to the pre-
pared work area. Ensure the fork is centered under the crate before lifting.
Note: Use a forklift with a minimum load capacity of 300 pounds (136 kg) and a fork
length that is a minimum of 40 inches (102 cm) so the fork fully extends beyond the crate
on the other side. The forklift should only be operated by a licensed/certified operator.
2, Unpack the Crate.
a. Remove the top and sides from the TM-402 crate. Set aside.
b. The TM-402 is shipped partially disassembled, with the Bowl Feeder, Take-up Arm
and Carrier Tape/Feed Arm detached and wrapped in bubble wrap. Remove the smaller
items one at a time from the crate and place on a flat, stable surface for assembly.
c. Remove and discard the protective wrapping from each part.
D292105.4a.fm Assembling the TM-402
Chapter 1: Assembly & Installation 1- 7
3. Remove the TM-402 from the Crate.
a. The TM-402 is bolted to the bottom of the crate for shipping. Reach below the crate to
unfasten the bolts.
Note: If the optional 80/20 Frame was purchased, follow the assembly instructions in the
80/20 Frame Exploded Views document which can be found in the Exploded Views sec-
tion at the end of this manual before proceeding.
b. Moving the TM-402 Base Machine. The machine may be manually lifted from the
crate. The base machine weighs 265 lb. (120 Kg) so the task will require four people.
Position one person at each corner of the machine using the lift points illustrated above to
safely distribute the machine’s weight. Lift the machine from the crate and place it onto
the prepared work table/bench.
4. Position the TM-402 in the work area so there is at least 3 feet of clearance on all sides.
(See the Preparing the Work Area section earlier in this chapter for details.)
5. The TM-402 is shipped with zip ties securing the pick head, the 2D Camera and any
mobile portions of the machine. Cut and remove all zip ties.
Lift Points
1-8 TM-403 User’s Guide
Assembling the TM-402 D292105.4a.fm
Re-assemble the TM-402
1. Position the Tower Light
Lift Tower Light, snapping it in place in an upright position perpendicular to the TM-402.
2. Connecting the Carrier Tape Arm
a. Remove the black knob from the right side of the Track Support Bracket.