编带机说明书-含图纸ttm402.pdf - 第76页

4-4 TM-403 User’s Guide Home Motors D292105.7b.fm Home Motors Note: The TM-402 needs to be homed once af ter each power up or Emergency St o p activat ion. The HMI will prompt the operator to home the motors whenever it …

D292105.7b.fm Power Up the System

Chapter 4: Setup 4- 3

Power Up the System

1. Power up the machine by turning the Main Power control on the

lower right side of the cabinet to the ON position.

2. Press the blue Reset Button on the left side of the machine.

There will be a brief popping sound as the Air Dump Valve

releases air to the machine. As the TM-402 powers up the PLC,

Servo Drivers and HMI Monitor will boot up. On top of the

machine, the Tower Light will flash red indicating the machine is

on but not running.

Note: The boot up process takes approximately 2 minutes.

The monitor will display the HMI Job Tab with a red Home Required message at

the top of the Tab Menu.

Step 1:

Power

4-4 TM-403 User’s Guide

Home Motors D292105.7b.fm

Home Motors

Note: The TM-402 needs to be homed once after each power up or Emergency

Stop activation. The HMI will prompt the operator to home the motors whenever it

is required. Once the motors have been homed, they remain homed until the

machine is powered down or the E-Stop is activated.

1. Press the red Home Required button at the top of the Tab Menu.

2. The TM-402 motor homing sequence begins with the pick head moving slowly to

the right towards the taper (X Axis movement).

When the head has stopped moving, homing is complete.

Step 2:

Home

Motors

D292105.7b.fm Load the Bowl Feeder

Chapter 4: Setup 4- 5

Load the Bowl Feeder

1. To prepare the Bowl Feeder for operation, ensure the correct Bowl and Linear

Track are installed for the part which will be run.

2. Load the Bowl with parts. Do not overfill.

3. On the HMI, select Bowl from the tab menu on the left to open the Bowl Setup

Tab..

4. Enable the Linear Vibratory. The Linear Track will turn on and activate the Bowl

5. Manually adjust the Vibratory Controls for Linear Track and Bowl as needed to

suit the type of component that is being processed. Parts should move fluidly into

the track and on to the nest.

Step 3:

Load the

Bowl Feeder