编带机说明书-含图纸ttm402.pdf - 第168页
7-12 TM-403 User’s Guide System Alarm Messages D292105.9b.fm Vision Err or System Alarm The 2D Inspection System is mounted on the T aper between th e place point and the Sealer . It inspects pa rts for mark and orient a…
D292105.9b.fm System Alarm Messages
Chapter 7: Troubleshooting 7-11
Tape Jam Sensor System Alarm
The Tape Jam Sensor is located on the Taper Track just
before the Sealer. It detects when parts are protruding
above the top of the pocket due to a misplaced part or
tape jam.
When the Tape Jam sensor is enabled and a jam occurs, operation stops, a beep sounds and a
warning appears on the HMI.
Clear the tape jam and then press CONTINUE to clear the error message and continue opera-
tion.
7-12 TM-403 User’s Guide
System Alarm Messages D292105.9b.fm
Vision Error System Alarm
The 2D Inspection System is mounted on the Taper between the
place point and the Sealer. It inspects parts for mark and orienta-
tion. It also detects empty pockets
If the 2D Inspection System detects an inspection error, the 2D
Inspection System Alarm will be activated. Tape advance stops,
a beep sounds and a warning appears on the HMI.
To clear the Vision Error system alarm, re-orient or replace the failed part under the 2D Inspec-
tion Camera. Press CONTINUE to clear the alarm and resume operation.
D292105.9b.fm System Alarm Messages
Chapter 7: Troubleshooting 7-13
Inspection Time-out System Alarm
If the 2D Inspection System fails to inspect a part within a preset time period, the Inspection
Time-out System Alarm will be activated. Tape advance stops, a beep sounds and a warning
appears on the HMI.
To clear the Inspection Time-out System Alarm, ensure the 2D Inspection Camera is connected
to power and setup correctly. Press CONTINUE to clear the alarm and resume operation.