00194440-10_SM_X-Series_Customer_en.pdf - 第254页

Measuring Equipmen t and Tools Component Sensor Protective Cap (CPP) [03080984-xx] 4.1.1 Scope of Delivery 254 Service Manua l SIPLACE X Series 4.18 4 . 1 8 C o m p o n e n t S e n s o r P r o t e c t iv e C a p ( C P P …

Measuring Equipment and Tools

4.1.1 Scope of Delivery Mapping Test Plate 520x300 mm [03067312‑xx]

Service Manual SIPLACE X Series 253

4.15

4.15 Mapping Test Plate 520x300 mm [03067312-xx]

Mapping Test Plate 520x300 mm [03067312-xx]

4.16

4.16 ACT Calibration Plate, Single Set, for Quad Lane [03073073-xx]

ACT Calibration Plate, Single Set, for Quad Lane [03073073-xx]

4.17

4.17 Setting Gauge for Board Clamping [00369202-01]

Setting Gauge for Board Clamping [00369202-01]

A special mapping plate with a width of 300 mm has been

developed for the quad lane machines. These machines

can only be mapped with this mapping plate, as the con-

veyor can not be set to a width of 450 mm.

ACT calibration plate, single set, for quad lane

[03073073-xx]

Setting gauge for board clamping [00369202-01]

Measuring Equipment and Tools

Component Sensor Protective Cap (CPP) [03080984-xx] 4.1.1 Scope of Delivery

254 Service Manual SIPLACE X Series

4.18

4.18 Component Sensor Protective Cap (CPP) [03080984-xx]

Component Sensor Protective Cap (CPP) [03080984-xx]

Component sensor protective cap for the CPP head

[03080984-xx]

Settings

5.1.1 Travel Ranges and Speed Monitoring at the X3 (A363) Gantry Settings

Service Manual SIPLACE X Series 255

5 Settings

Settings

5.1

5.1 Gantry Settings

Gantry Settings

5.1.1

5.1.1 Travel Ranges and Speed Monitoring at the X3 (A363)

Travel Ranges and Speed Monitoring at the X3 (A363)

The travel range of the X and Y axes will be determined automatically with the SITEST program. This

means that during calibration of the travel range of gantry 3 at placement area 2, the respective axis

moves as far as possible into its minimum and maximum position, until both proximity switches switch.

A safety gap before the hardware limit switch is calculated for each individual machine (see travel ranges

HF). For the Y axis of placement area 1, gantry 1 moves just to the minimum position and gantry 4 to

the maximum position.

Travel range X and Y axes of X3 machine

1. The calculation of travel ranges for the X axes at gantries 1/3/4 and of the Y axis at gantry 3 follows

the same procedure as the calculation for HF machines.

2. The travel range for the Y axes are calculated partly. This means that the Y axis of gantry 1 moves

into the minimum position and the Y axis of gantry 4 moves into the maximum position. As a result:

maximum position gantry 1 = maximum position gantry 4 - 480mm (gantry width) - 20mm safety

space. (In X4 machines, the travel ranges are set accordingly for gantry 2) Minimum position

gantry 4 = minimum position gantry 1 + 480 mm (gantry width) + 20 mm safety distance. (In X4 ma-

chines, the travel ranges are set accordingly for gantry 3)

3. Safety space approx. 20mm