00194440-10_SM_X-Series_Customer_en.pdf - 第320页
Settings Conveyor Settings 5.4.1 Adjusting the Tension of the Conveyor To othed Belt 320 Service Manua l SIPLACE X Series Measuring and setting the belt te n sion for the width adjustment 1 Adjustment unit 4 Toothed driv…
Settings
5.4.1 Adjusting the Tension of the Conveyor Toothed Belt Conveyor Settings
Service Manual SIPLACE X Series 319
5.4
5.4 Conveyor Settings
Conveyor Settings
5.4.1
5.4.1 Adjusting the Tension of the Conveyor Toothed Belt
Adjusting the Tension of the Conveyor Toothed Belt
NOTICE
Measuring at strand center
The belt tension is measured at the strand center (i.e. the longest distance between the two
deflection pulleys).
Measuring and setting the tension of the conveyor
toothed belt
1. Deflection pulley with slot
2. Measuring point of the belt tension measuring device
► Each conveyor section contains a deflection pulley
(1), that can be moved. The tension of the conveyor
toothed belt can be adjusted by moving this deflection
pulley.
► Position the measuring point of the belt tension de-
vice at the strand center (i.e. the longest distance be-
tween the two deflection pulleys) of the conveyor
toothed belt.
► Set the tension of the conveyor toothed belt accord-
ing to the following values.
NOTICE
Different frequencies
The tension frequencies per area may vary according to the different belt guides. The belt ten-
sion always remains the same.
Settings
Conveyor Settings 5.4.1 Adjusting the Tension of the Conveyor Toothed Belt
320 Service Manual SIPLACE X Series
Measuring and setting the belt tension for the width adjustment
1 Adjustment unit 4 Toothed drive belt for adjusting the width /
measuring the belt tension
2 Spindle with toothed wheel
3 Width adjustment stepping motor 5 Transport direction
Width adjustment motor
The belt is tensioned by means of cams on the idler pul-
leys. The idler pulleys are located on the left and right of
the motor.
1. Loosen the cam shaft on the idler pulley and set the
belt tension.
Settings
5.4.1 Adjusting the Tension of the Conveyor Toothed Belt Conveyor Settings
Service Manual SIPLACE X Series 321
5.4.1.1
5.4.1.1 Belt Tension of PCB Conveyor (SIPLACE X, D3)
Belt Tension of PCB Conveyor (SIPLACE X, D3)
Conveyor belt tension settings
NOTICE
Different belt lengths
The modular conveyor uses different belt lengths. The different belt tensions between the con-
veyor lanes are due to the different arrangement of hexagonal shafts and deflection pulleys.
Belt tension For lane 1
(single and dual conveyor)
For lane 2
(dual conveyor)
Belt tension for the width ad-
justment
30 Hz +/- -2 Hz
Input belt 102 Hz +/- -10 Hz 144 Hz +/- -14 Hz
Placement area 1 66 Hz +/- -7 Hz 71 Hz +/- -7 Hz
Intermediate conveyor (X se-
ries, D3)
94 Hz +/- -9 Hz 94 Hz +/- -9 Hz
Intermediate conveyor (quad
lane, X4I)
77 Hz +/- -8 Hz 77 Hz +/- -8 Hz
Placement area 2 66 Hz +/- -7 Hz 71 Hz +/- -7 Hz
Output belt 102 Hz +/- -10 Hz 144 Hz +/- -14 Hz
Toothed belt for drive unit 245 +/-25 Hz