YSP20_Users_E.pdf - 第100页
4-8 4 aily operation 5.1 Using the same roll size 1 Open the co ver . 1. On the Setup screen, press the [SW Prod. Position] button and select “Mask Setup”. 2. When the DOOR LOCK lamp turns off, open the cover . c …
4-7
4
aily operation
5. Replacing the cleaning gauze roll
If the cleaning gauze roll is wound up completely or if the gauze roll with a different size needs to be used
during the setup work, follow the steps below to replace the cleaning gauze roll.
c
n
Gauze roll part No.
Part No. Part name Notes
KHT-M3660-00X BENCOT,ROLL 530 Roll sheet width, 530 mm
KGY-M3660-A0X BENCOT,ROLL 440 Roll sheet width, 440 mm
KGY-M3660-B0X BENCOT,ROLL 360 Roll sheet width, 360 mm
KGY-M3660-C0X BENCOT,ROLL 260 Roll sheet width, 260 mm
c
Select a gauze roll width that matches the squeegee head size. Using the wrong gauze roll width might damage the
squeegee head and mask.
c
below) under the mask plate.
Cleaning unit
Mask plate
Cleaning unitHandle
63403-N3-00
4-8
4
aily operation
5.1 Using the same roll size
1
Open the cover.
1. On the Setup screen, press the [SW Prod.
Position] button and select “Mask Setup”.
2. When the DOOR LOCK lamp turns off,
open the cover.
c
operation. Use it only when you want to stop the
machine immediately in case of emergency.
n
NOTE
When a mask of 736 x 736 or larger is used, remove it.
2
Remove the used up gauze roll
from the take-up shaft.
With the used up gauze roll kept pushed
leftward, remove it from the take-up shaft
(lower shaft) along with the shaft holder fit
into the right end of the used up gauze roll.
3
Fit the roll core remaining on the
upper roll shaft onto the take-up
roll shaft.
Remove the empty roll core by pushing it to
the left along with the shaft holder fit into
the right end.
Then, press-fit the empty roll core into the
take-up shaft (lower shaft).
4
Insert the shaft holder into a new
gauze roll.
Remove the shaft holder inserted into the
right end of the used up gauze roll and insert
it into the right end of a new gauze roll.
63404-N3-00
n
NOTE
On Lane 2, the direction of inserting the shaft holder is
opposite, so use caution.
n
NOTE
Pay special attention to the gauze roll feed direction
when inserting the shaft holder into a new gauze roll.
5
Fit the new gauze roll onto the
upper roll shaft.
While pushing the gauze roll to the left, fit it
onto the upper roll shaft. Make sure that the
guide on the shaft holder is engaged
securely.
Inserting the shaft holder.
Step 4
Shaft holder
Gauze roll feed direction
4-9
4
aily operation
6
Feed the gauze roll through the
guides.
While keeping the parallelism between the
left and right, feed the gauze roll through
the guides as shown in the figure on the
right.
63406-N3-00
c
gauze roll.
7
Attach the top end of the new
gauze roll onto the roll core
inserted onto the take-up shaft.
Fasten the top end of the new gauze roll
with an adhesive tape or similar item so that
both ends feed in parallel with each other.
After that, turn the take-up shaft 2 or 3
rotations to wind up the gauze roll.
8
Close the safety cover and cancel
the emergency stop.
Feeding the gauze roll through the guides.
Step 6
Take-up shaft
New gauze roll
Rear cover