YSP20_Users_E.pdf - 第126页
Chapter 5 Creating and setting the data T his chapter describes how to create new data necessary for solder printing and how to edit the data and parameters, as well as the definitions of parameters. Contents 1. Creating…
4-33
4
aily operation
5
Remove the mask from the printing table.
Turn the mask clamp switch to the left to unclamp the mask and then remove the mask.
6
Close the safety cover and press the [READY] button.
7
Quit the software.
Press the [Off] button on the operation display and follows the message that appears on the screen.
[Off] button
[Off] button
64422-N3-10
8
Turn off the power switch on the front right of the machine.
See "2.3 Turning off the machine" in Chapter 2.
9
Clean the squeegees and mask.
After detaching the squeegees and mask, clean them with the appropriate cleaner (available as
option) to wipe way the remaining solder and flux.
n
NOTE
To find how to correctly handle the mask and solder, refer to the instruction manual of the mask or solder
manufacturer.
c
How well you clean the mask you detached after use will greatly affect the production yield the next time that same
mask is used. Also handle the squeegee and mask carefully to avoid dents and scratches.
Chapter 5 Creating and setting the data
This chapter describes how to create new data necessary for solder printing and how to edit the data and parameters, as well
as the definitions of parameters.
Contents
1. Creating new data 5-1
3
3
5
5
0
4. 3
3
6
5. Squeegee data setting 5-19
5.1 Squeegee detail setting 5-23
6. Cleaner data setting 5-26
7. Creating the mark data 5-30
7.1 Creating procedure 5-31
2
7.3 Shape parameters 5-33
5
7
8. Graphic alignment 5-40
4
5-1
5
Creating and setting the data
1. Creating new data
First, you must register a new board name to create new data. Register a new board name as follows.
1
Press the [Create] button on the Setup screen.
The "Create Board Data" dialog box appears as shown below.
[Create] button
Create Board Data dialog box
64501-N3-10
2
Enter a board name in the "File name" box.
Enter a board name within 20 alphanumeric characters from the keyboard.
Do not use spaces and symbols other than underbars ( _ ) .
Entering a board name
Enter the board name and press [OK].
64502-N3-00