YSP20_Users_E.pdf - 第222页
7-18 7 ther functions 4. Manual operation When you press the [Unit] button, the following screen appears. This screen is divided by several tabs such as [Conveyor], [Mask], [Squeegee] and [Cleaner] to allow manually op…
7-17
7
ther functions
3. Backup pin arrangement
When you press the [Backup Pin Pos.] button on the [Print]-[Board] tab screen, the "Backup Pin" dialog box
appears. On the graphic view in this dialog box, you can register the backup pin arrangement according to
the board size.
"Backup Pin" dialog box
Shaded area
shows board
size.
23 4 5 6 7 1
[Lane] button
64715-N3-10
1: [Select] button
Press this button when selecting pins on the graphic view.
2: [Deselect] button
Press this button when canceling the pin selection made on the graphic view.
3: [Pointer] button
By pressing this button with the [Select] button depressed, you can select pins by clicking or dragging the mouse.
By pressing this button with the [Deselect] button depressed, you can cancel the pin selection by clicking or dragging the
mouse.
4: [Draw Line] button
By pressing this button with the [Select] button depressed, you can select pins by drawing a line (dragging the mouse).
By pressing this button with the [Deselect] button depressed, you can cancel the pin selection by drawing a line (dragging
the mouse).
5: [Draw Rectangle] button
By pressing this button with the [Select] button depressed, you can select pins by drawing a rectangle (dragging the
mouse).
By pressing this button with the [Deselect] button depressed, you can cancel the pin selection by drawing a rectangle
(dragging the mouse).
6: [Select All Pins] button
Click this button to select all pins on the graphic view.
7: [Deselect All Pins] button
Click this button to cancel all pins you selected on the graphic view.
7-18
7
ther functions
4. Manual operation
When you press the [Unit] button, the following screen appears. This screen is divided by several tabs such
as [Conveyor], [Mask], [Squeegee] and [Cleaner] to allow manually operating the servo-controlled units. You
can also check the status of each sensor and I/O signal on the [I/O] tab screen.
Unit screen
Selection tab
64716-N3-10
7-19
7
ther functions
4.1 "Move Axis" screen
Pressing the [Axis] button on the Unit screen opens the "Move Axis" screen as shown below. You can use this to
manually move the unit on each axis.
"Move Axis" screen
Selection tab
Select the lane.
64717-N3-10
Selection tab Function
X/Y Moves the board clamp unit in the X and Y directions.
SY/SZ Moves the squeegee head in the Y direction, or vertical direction.
SR Turns the squeegee head. (3S head only)
MY1/MY2 Moves the mask (stencil) stage in the R direction.
MZ Moves the mask (stencil) stage in the Z direction.
Width Adjusts the conveyor width.
PU Raises and lower the push-up plate.