YSP20_Users_E.pdf - 第223页
7-19 7 ther functions 4.1 "Move Axis" screen Pressing the [Axis] button on the Unit screen opens the "Mo ve Axis" screen as shown below . Y ou can use this to manually move the unit on eac h axis. &…
7-18
7
ther functions
4. Manual operation
When you press the [Unit] button, the following screen appears. This screen is divided by several tabs such
as [Conveyor], [Mask], [Squeegee] and [Cleaner] to allow manually operating the servo-controlled units. You
can also check the status of each sensor and I/O signal on the [I/O] tab screen.
Unit screen
Selection tab
64716-N3-10
7-19
7
ther functions
4.1 "Move Axis" screen
Pressing the [Axis] button on the Unit screen opens the "Move Axis" screen as shown below. You can use this to
manually move the unit on each axis.
"Move Axis" screen
Selection tab
Select the lane.
64717-N3-10
Selection tab Function
X/Y Moves the board clamp unit in the X and Y directions.
SY/SZ Moves the squeegee head in the Y direction, or vertical direction.
SR Turns the squeegee head. (3S head only)
MY1/MY2 Moves the mask (stencil) stage in the R direction.
MZ Moves the mask (stencil) stage in the Z direction.
Width Adjusts the conveyor width.
PU Raises and lower the push-up plate.
7-20
7
ther functions
n
Manual axis movement
This section describes how to use the buttons on the "Move Axis" screen, using the [SY/SZ] tab as an example.
"Move Axis" screen
[SY/SZ] tab
4
2
3
1
64718-N3-00
1: SY-axis movement buttons, [PTP] button, [Brake] button
Pressing the arrow buttons moves the squeegee head in the Y direction. When the [Step Mode] button is in the depressed
state, the squeegee head moves at the specified step stroke each time the arrow buttons are pressed.
Pressing the [PTP] button displays the "PTP" dialog box. You can directly specify the position where you want to move the
squeegee head. The current position is displayed in the "SY (mm)" box.
The [Brake] button turns the SY-axis brake on or off.
2: SZ-axis movement buttons, [PTP] button, [Brake] button
Pressing the arrow buttons moves the squeegee head vertically. When the [Step Mode] button is in the depressed state,
the squeegee head moves at the specified step stroke each time the arrow buttons are pressed.
Pressing the [PTP] button displays the "PTP" dialog box. You can directly specify the position (height) where you want to
move the squeegee head. The current position is displayed in the "SZ (mm)" box.
The [Brake] button turns the SZ-axis brake on or off.
3: [Step Mode] button
Press this button to set axis movement to "step mode (inching mode)". (The button will remain depressed until you press
it again to exit "step mode".)
Specify the step stroke (inching stroke) with the arrow button or enter it directly in the "Step Stroke" box.
4: "Speed (%)" box
Select the speed to move the unit.
TIP
A [Brake] button is displayed on the tab for the axes equipped with a brake and can be used to turn the motor brake
on or off.
c
button.