2OM-1088-002.pdf - 第18页
Safe-5 Tg0698-PM-D1 Safety Precautions W ARNING Be sure to handle industrial alcohol carefully because it is inflammable and acutely toxic. Keep industrial alcohol away from any heat of fire because it can catch fire ver…
Safe-4 Tg0698-PM-D1
Safety Precautions
0509-001
Precautions before Use
Confirm that no covers are disengaged before operating the
machine.
If the machine is used with its cover(s) being detached, a
serious accident may occur.
Be sure to attach them in place.
Make certain that no person or object comes in contact with the
moving mechanisms of the machine. Then, check safety and
power up the machine to start operation.
Do not start the machine unless those working in the immediate
area of the machine are aware of hazards from moving parts.
Do not modify the machine nor use any parts other than the
specified ones. Be sure not to use the machine with its safety
devices detached. Doing otherwise may cause personal injury.
Do not change the settings of OS (Operating System) or install
any applications additionally.
Do not set the [OPERATION/SETUP] switch to the "SETUP"
side for any operations other than setup purposes.
When the switch is set to the "SETUP" side, setup operations
become possible with the safety door being open. It is very
dangerous to operate the machine without safety check. Be
sure to pay special caution while operating the machine.
DANGER
Safe-5 Tg0698-PM-D1
Safety Precautions
WARNING
Be sure to handle industrial alcohol carefully because it is
inflammable and acutely toxic.
Keep industrial alcohol away from any heat of fire because it
can catch fire very easily.
It is also advisable that smoking or any heat source near the
machine be avoided.
Before starting the machine and after a setup operation, be
sure to check if any industrial alcohol is leaking from a crack of
the hose joint or the hose itself running between the solvent
tank and the cleaning nozzle.
Do not operate the machine while industrial alcohol is leaking.
Otherwise, the leaking alcohol may catch fire easily.
Refer to "4. Daily Maintenance" and "12.2 Checking of Industrial
Alcohol Hose and Joints" (Section 1 in chapter 3 (Vol. 2)) for
the areas to be checked.
Whenever a leakage is found, contact our service person.
Do not change the set pressure of the regulator that is used to
pressurize the solvent tank.
(Regulator Set Pressure: 0.01 MPa)
If more than the specified pressure is applied, the tank may
explode.
[kgf/cm
2
]
MPa
0.01 MPa
SMC
0
2
1
0.5
1.5
0.05
0.15
0
0.2
0.1
Knob
0509-001
Before performing the automatic operation, be sure to remove
the selection key for the [OPERATION/SETUP] switch.
The key shall be kept removed (excluding the time of setup
operations) and stored by the person in charge.
Safe-6 Tg0698-PM-D1
Safety Precautions
0509-001
CAUTION
• Attach the internal lid and tighten the cap securely.
If the cap gets loose, adequate pressure may not be
applied or the solvent may leak out.
Even after the [EMERGENCY STOP] switch is pressed, note
that electrical power is supplied to the control device.
To shutdown the power to all loads, set the power breaker to
"OFF".
When an "Emergency Switch Off" function is required, it must be
prepared on the customer side.
Emergency Switch Stop : Emergency Interception of Controlled Load
Power Sources
Emergency Switch Off : Emergency Interception of All Load Power
Sources
Cap
Tank
Internal Lid
Solvent Tank
In principle, the overall operation of the machine including the
button operations on the operation panel and the touch screen
must be controlled by only one person.
If there are more than one, ensure good communication by giving loud
verbal instructions.