2OM-1088-002.pdf - 第361页

Tg0699-PM-D2 Clip 9.2 Cleaning Procedure of Blower Filter Operation Procedure (1) Remove the cover located at the lower part of the rear side. (6 screws) Fig. 5A61 (2) Disengage the clip fastening the lid of the filter c…

Tg0699-PM-D2

0207-001 Chapter 3 1-41

9.1 Replacement of Squeegees

(3) Open the "SEMI-AUTO OPN." window (submenu) or the "Print

Block" tab sheet of the "MAN. SUB-SYS" window (submenu)

and push the squeegee against the P.C.B. located in the printing

section.

Refer to the above table and check the relation between Dimen-

sion L and the pushing distance.

(a) When the rubber squeegees are worn out, the push-ing

distance becomes as short as they are worn out. There-

fore, it is required to change the rubber squeegees

before the pushing distance is changed greatly (in the

range of 0.5 mm or less).

(b) The rubber squeegees can be ground to be re-used. In

this case, the total of the dimension (grinding) is limited

to "1.5 mm" (when the maximum pushing distance is

"0.5 mm").

When the total of the dimension (grinding) has become

"1.5 mm", be sure to replace the rubber squeegees with

new ones.

lower the location of the stopper nuts according to the

dimensions of the ground rubber squeegees (the squee-

gees that have become shorter after grinding) so that

the same pushing distances can be kept.

Tg0699-PM-D2

Clip

9.2 Cleaning Procedure of Blower Filter

Operation Procedure

(1) Remove the cover located at the lower part of the rear side.

(6 screws)

Fig. 5A61

(2) Disengage the clip fastening the lid of the filter cover.

(4 places)

Fig. 5A62

(3) Remove the lid.

Fig. 5A63

0207-001 Chapter 3 1-42

9.2 Cleaning Procedure of Blower Filter

Cover

Tg0699-PM-D2

0207-001 Chapter 3 1-43

9.2 Cleaning Procedure of Blower Filter

(4) Detach the filter and remove dust accumulated on the filter with

an air gun and a vacuum cleaner.

Fig. 5A64

(5) Set the filter such that the center hole of the filter can fit into the

flange located at the rear side of the filter cover.

Fig. 5A65

(6) While holding the lid, engage the clip securely such that the

flange (located at the center of the lid) can fit into the center

hole of the filter.

Fig. 5A66

Flange Section