GL541操作手册.pdf - 第12页

Part One GL-541E Machine Operation

Introduction

This manual is divided into five parts.

Part One, GL-541E Machine Operation, explains the basic operation, error displays, etc., of the

GL-541E.

Part Two, Automatic Operation and Programming, provides a detailed explanation of the role of

Proper data items in automatic operation, as well as the use of the glue check and block skip

functions. The information in this part is essential to understanding the use of the machine in

regular production.

Part Three, GL-541E Commands, explains the use of each of the function keys. Refer to this

section for the commands necessary to carry out a desired operation or when you do not

understand the meaning of a particular command.

Part Four, Proper Data, describes the Proper data associated with the GL-541E.

Part Five, Vision Processing, describes the functions available for inspecting fiducial marks, block

skip marks and for checking glue dots.

Part Six, Errors and Countermeasures, explains each error and what action to take in response.

Appendix A, I/O Map, lists all the I/O signals.

Version 2.0

Part One

GL-541E Machine Operation

Part 1

1 - 1

Version 2.0

Chapter 1 Outline of the Machine

1. Outline of the Machine

1.1 Connecting the Power Supply

(1) Power consumption

The power consumption of the GL-541E is approximately 2 kVA. Connect the

machine to a power supply with a capacity of at least 10.0 kVA.

(2) Power cables

Use power cables with a cross-section area of at least 3.5 mm

. Overheating or

voltage drop may occur if the cable diameter is too small.

(3) Power connections

The hole for the power cable is in the side of the control box, which is located at the

bottom of the machine. Pass the primary 200 V AC power supply cable through this

hole. Connect the R, S, and T phases to the terminals on the top of the circuit

breaker in order from left to right. Connect the ground lead to the ground terminal.

1.2 Connecting to F4G

First, register the GL-541E in the C/C line descriptor (refer to the F4G manuals). Then

connect the communication cables to the C/C connector that was set in the line

descriptor. The connector on the GL-541E is located at the rear of the control box at the

bottom of the machine.

GL-541E Operation