GL541操作手册.pdf - 第207页
Part 5 5 - 7 V ersion 2.0 Chapter 2 T race Mode No.14 Detail This displays all of the graphic functions along with the detailed data for each respective function. A trackball must be used if this setting is utilized. No.…
Chapter 2 Trace Mode
Part 5
Note: The [TRACE] command section is used to specify the trace mode. The display at the
vision processing monitor differs depending on the combination of the trace settings.
The settings carried out here may affect automatic or step operation. Depending on the
mode settings, the speed of vision processing may be decreased. Remember that this
function is only for debugging and not for use during production.
2.2 Descriptions of the Trace Settings
A description is given below of each item that can be set in the trace mode.
For additional information refer to the SMD3 Operation Manual.
No.0 Result
This carries out the graphic display of the vision processing results.
No.1 Tole
This displays a tolerance graph overlapping the vision processing results.
No.2 Window
This is utilized when vision processing is checked using calipers.
No.3 Point
During the inspection of all processes, if there is a designated window for the algorithm
the position and size of the window will display.
No.4 Line
This carries out the display of the designated points.
No.5 RS232C
The vision processing data is output to the terminal via an RS232C cable.
No.13 Color
This is used to change the color of the graphical display to black. Normally when this is
not set, graphs will display in white.
5 - 6
Version 2.0
GL-541E Operation
Part 5
5 - 7
Version 2.0
Chapter 2 Trace Mode
No.14 Detail
This displays all of the graphic functions along with the detailed data for each respective
function. A trackball must be used if this setting is utilized.
No.15 Pause
Set flags when the trackball is used. This is used in combination with other functions.
No.24 Clp
This is used to verify the processing of the algorithm that is utilized with the caliper
function.
No.25 Blob
This is used to verify the processing of the algorithm that is utilized with blob analysis
processing.
No.26 Agf
This is used when a detailed check of the angle finder is carried out.
No.27 BT
This displays the results of boundary tracking on the vision processing monitor.
No.30 AcqTime
This is used when the vision processing acquisition time is output from the parallel I/O.
(Normally this is not used.)
No.31 InsTime
This is used when the vision processing time is output from the parallel I/O. (Normally
this is not used.)
GL-541E Operation
Chapter 2 Trace Mode
Part 5
5 - 8
Version 2.0
GL-541E Operation