GL541操作手册.pdf - 第228页

Part 6 6 - 13 V ersion 2.0 Chapter 1 Errors Displayed by the GL-541E 1.3 Printing Data T race for T roubleshooting Attach the F4G printer cable to the CPU board connector. The CPU board is located on the left side of the…

Chapter 1 Errors Displayed by the GL-541E

Part 6

0012

Cause: Currently not used.

0013

Cause: As for 0011 but placing is at 90 degrees and 270 degrees.

6 - 12

Version 2.0

GL-541E Operation

Part 6

6 - 13

Version 2.0

Chapter 1 Errors Displayed by the GL-541E

1.3 Printing Data Trace for Troubleshooting

Attach the F4G printer cable to the CPU board connector. The CPU board is located on

the left side of the control box as shown in the figure below. If the machine behaves

erratically, a printout of the sequence of events which caused the problem can be

obtained.

To obtain a trace list perform the following. Switch off the machine power by pressing

the POWER OFF button and then while holding down the CYCLE STOP button press the

POWER ON button. However, if an OS error occurs, do not switch off the machine

power. Instead press the RST (reset) button on the CPU board while holding down the

CYCLE STOP button. If the power is turned off when as OS error occurs, the code will

be changed preventing the error from being accurately identified.

Note: Make the printout immediately after the failure occurs and consult Fuji.

Data about the machine operation is stored in a ring buffer. Therefore, if an operation is

carried out after the error occurs, it may delete this information from the machine. It

may not be possible to print out the trace data following the occurrence of certain types

of errors.

GL-541E Operation

Appendix A

I/O Map